Intracom Telecom G5EVOBS2729 Gigabit Base Station Radio User Manual
- June 5, 2024
- Intracom Telecom
Table of Contents
G5EVOBS2729 Gigabit Base Station Radio
User Manual
Gigabit Base Station Radio
FCC Part 15.19 Statement: Information to the User
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Part 15.21 Statement: Information to the User
Changes or modifications made to this equipment, that are not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
FCC Part 15.105 Statement: Information to the User
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to protect reasonably against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. Suppose this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off. In that case, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. In order to avoid the
possibility of exceeding the FCC radio frequency exposure limits, this
equipment should be installed and operated with a minimum distance of 670 cm
between the antenna and your body during normal operation. Users must follow
the specific operating instructions for satisfying RF exposure compliance.