HORNBACH 6758657 LED battery operated 1m sensor strip Instructions

: June 5, 2024
: HORNBACH

Table of Contents

HORNBACH 6758657 LED battery operated 1m sensor strip
Assembly instructions
Safety information
For use of batteries
Assembly
Motion Sensor
Battery Replacement
Maintenance and care
- Cleaning
Technical data
- Used symbols
Manufactured for
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

HORNBACH 6758657 LED battery operated 1m sensor strip

Assembly instructions

Description

Movement sensor
MAN/AUTO switch
ON/OFF button
Battery box incl. 4 (separated) batteries
Light strip

Please read these instructions carefully and keep them safe for later use!

Safety information

Electrical work and repairs must be performed by a qualified electrician.
During installation, always observe the national installation regulations.
The luminaire must not be modified in any way. Risk of electric shock and accident.
This article is not a toy. Do not use it in nurseries.
Do not look directly into the LED beams.
The light source of this luminaire is not replaceable; when the light
Source reaches its end of life the whole luminaire shall be replaced.

For use of batteries

CAUTION!

Explosion hazard when the batteries are not replaced correctly.
Only replace by batteries of the same type. Pay attention to the correct polarity.
Do not expose batteries (battery pack] or inserted batteries) to excesSIVe heat] from sunlight, fire, etc. Protect from mechanical shocks. Keep dry and clean. Keep out of reach of children.
Do not open, disassemble, cut open, or short-circuit batteries. Do not use old and new batteries together.
Observe the safety notes and other] notes on the battery and its packaging.
Remove leaking batteries and clean the battery compartment thoroughly. Avoid contact with eyes and skin.

Assembly

Caution: Do not attach the light A strip ver sharp edges. Make sure that the underground is flat or has a ra dius larger than 30 mm at angles above 60.

Remove batteries. Cut the light strip 5 at the cutting mark to the desired length.
Remove the self-adhesive tape at the back of the light strip.
Affix the light strip at the desired location by pressing it lightly with the fingers onto the surface.
Insert batteries (see IV.) In order to install battery box 4, remove the 3M adhesive tape and use the pre-installed velcro fastener at the backside to install it on the wall.

Caution: Fully unwind the light strip before inserting the batteries.

Motion Sensor

Use the MAN/AUTO switch 2 to change the mode of operation.

AUTO: The light strip switches on automatically when movement is detected within a sens-m ing range of 100°. After 30 sec onds the light strip switches off.
MAN: The light strip can be turned on/off with the ON/OFF button 3.

Note: Keep movement sensor 1 on the light strip uncovered and free of obstacles for proper functioning.

Battery Replacement

To change the battery, remove the battery cover at the backside of the battery box.
Observe the correct polarity and replace the batteries by the same type of battery (Type AAA). Put the battery cover back in place.

Maintenance and care

Caution: The light source is not replaceable.

Cleaning

Wipe the luminaire with a soft, dry cloth only.
Never use scouring powders or chemical cleaning agents.
Never allow the electrical compa0- nents to become damp.

Technical data

Battery type: 4x AAA 1.5 V
Voltage: 6V DC
Rated power: 2.8 W
Degree of protection: IP20
Colour temperature: 4000 K
Light Source: LED -non- replaceable!
Size: 1000x8x2 mm
Luminous flux: 130 I’m
Sensor detection distance: approx. 4 m

Used symbols

Caution

Risk to health and the product.
Do not use outdoors or in damp environments.

Waste disposal

The pictogram with the crossed-out dustbin points to the requirement for separate disposal of electrical and electronic appliances (WEEE). Electrical and electronic appliances can contain hazardous and envi-ronmentally hazardous materials. Do not dispose of this appliance as domestic waste. Hand it in at a collection point for electrical and electronic waste. By doing so, you will help to conserve resources and protect the environment. For further details, please consult your local authorities. Used batteries must be disposed of properly. Battery selling stores and municipal collection points offer special containers for battery disposal.