BURLEY 09 D’Lite Encore and Solo Child TrailerS Instructions
- June 5, 2024
- BURLEY
Table of Contents
Installation Instructions
for ‘09 delete ™ , Encore ® and Solo ™
(Euro) Child Trailers
Contents:
-
Burley Owner’s Instruction and Safety Manual
(1) Hitch
(1) Clear light with batteries included
(1) Red light with batteries included -
Phillip Pan screws
(2) Brackets for lights -
Wheel guard assembly:
-
wheel guards
(4) screws
(1) 5mm hex key wrench
Tools Required: Phillips screwdriver
4mm hex wrench
10mm or open end wrench
Note: Consult your Burley Owner’s Instruction and Safety Manual for wheel
guard and hitch installation instructions.
Roll Bar Installation
- If handlebar receivers are already installed, loosen and remove handlebar knobs and outer handlebar receivers. Figure 1
- Using wrench, loosen and remove lock nuts and screws from handlebar receivers.
- From trailer front, slide roll bar into upper handlebar receivers, with curved front extending above trailer body.
- Match holes in the roll bar and inner handlebar receivers, re-install screws and tighten lock nuts.
- Replace outer handlebar receivers and tighten knobs.
Light Installation
Note: Clear light is mounted facing forward, on the side closest to
traffic. The red light is mounted facing the rear, on the side closest to
traffic.
Note: Make sure on/off light switches are accessible.
- Remove clips and screws from the back of the lights.
- Using screws, fasten brackets and lights together.
- Mount clear light/bracket diagonally on the front of the roll bar and red light/bracket on the rear of roll bar, both on side closest to traffic. PHOTO 1
Locking Quick Release/ Wheel Installation and Operation
- With quick release lever in “open” position, insert wheel axle completely into trailer axle receiver.
- Close quick release lever, with lever aimed towards the rear of the trailer. PHOTO 2
- Verify that tires are inflated to pressure marked on the tire side wall.
- To remove the wheel from the trailer axle, push the locking button on side of quick release lever and open lever.
Note: The locking quick release lever securely attaches the wheel to the trailer. If you have difficulty removing the wheel, release pressure on the quick release by pushing the end of lever in toward the trailer before pushing the locking button.
WARNING
MAKE SURE WHEELS ARE HELD SECURELY, WITH THE WHEEL SHAFT FULLY INSERTED INTO
THE AXLE RECEIVER. YOU SHOULD NOT BE ABLE TO ROCK OR SHIFT WHEELS. IMPROPERLY
INSTALLED WHEELS CAN FALL OFF, CAUSING AN ACCIDENT OR SERIOUS INJURY.
BU R L EY DES I G N
Copyright © 2008 by Burley Design LLC. “Burley” is a registered trademark
of Burley Design LLC: Rev 06/08: 170056 Euro delete,
Encore, and Solo Installation Instructions r1 4020 Stewart Rd. Eugene, OR
97402: PH 541. 687.1644 800.423. 8445
FAX 541.687.0436 : burley@burley.com :
www.burley.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>