LEZYNE Micro Drive 1300XXL LED Bike Light User Manual
- June 5, 2024
- Lezyne
Table of Contents
LEZYNE Micro Drive 1300XXL LED Bike Light
READ ENTIRE MANUAL BEFORE OPERATION to ensure proper use and care of your new
Lezyne LED light. Traffic laws mandating lighting vary from country to
country. Inform yourself about lighting laws and regulations in the country of
use. Lezyne LED lights do not conform to the German road traffic regulation
Stvzo.
Warnings
- DO NOT L0OK DIRECTLY INTO LIGHT BEAM Or shine into the eyes of another.
- Lezyne LED Lights have a water resistance rating of IPX7 under IEC standard 60529. Submerging the device is not recommended. If moisture does enter the casing, air out until completely dry.
- DO NOT ATTEMPT TO REMOVE ELECTRONICS. Doing so will void warranty.
- Lezyne USA, Inc. does not accept any liability for injuries or other damages resulting from the use of this product in any circumstances.
Warranty
In U.S. and U.K., Lezyne LED Lights carry a two (2) year warranty from the
original purchase date to the original owner (proof of purchase required).
Lezyne Batteries carry a six (6) month warranty from the original purchase
date. Lezyne warranties cover any manufacturing defects in materials or
workmanship. Issues not covered by warranty include normal wear & tear,
improper installation, attempting to access or modify electronics, damage or
failure due to accident, misuse, abuse, and/or neglect.
For all warranty issues worldwide, please contact the retailer that sold the
product. For any warranty questions contact:
warranty@lezyne.com
Mounting
Operation
- On/Off: hold the button two (2) sec.
- Mode cycle: click the button
RACE MODE: With the light OFF, hold the button for five (5) seconds,
until light flashes.
The light is now in Race Mode where only Overdrive and Economy outputs are
selectable. The light will remain in Overdrive Race Mode even when switched
OFF. Repeat the step above to return to the normal mode set.
MODE MEMORY: The light remains in the output setting it is switched OFF
in.
THERMAL PROTECTION: If the operating temperature of the light is too
high, the light automatically lowers the lumen output.
Run Times and Modes
MACRO DRIVE 1300XXL
LITE DRIVE 1000XL
MICRO DRIVE PRO 80OXL
Battery Indicator
An LED, located in the button, displays the current battery status while light
is ON. When light is OFF. click the button once to momentarily display battery
status. 
Charging
Before using your Lezyne LED Light for the first time, fully charge the battery.
To charge your light:
-
Switch light OFF
-
Remove USB protective cover
-
Connect the micro USB cable and light to the powered USB port
-
Once charging, the button will flash green; if USB port is capable, light will use High Efficiency (HE) charging and button will flash blue
If the button does not flash when plugged in, a selected USB port may not be powered-try another USB port.
Light will be charged after 4-8 hours (2.5-6 with HE charging) or when the button illuminates solid green or blue. -
Remove light from the charger and reinstall USB protective cover-ensure USB protective cover is fully installed for water resistance
More Information
For more information on Lezyne products, visit:
www.lezyne.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>