Polibi RS-677VUB-QB Velvet Upholstered Bed Instruction Manual
- October 30, 2023
- Polibi
Table of Contents
Polibi RS-677VUB-QB Velvet Upholstered Bed
Thank you for purchasing this quality product. Be sure to check all packing
material carefully for small part that may have come loose inside the carton
during shipment.
If you have any questions about the product, please contact the email:
Polibihd@outlook.com
PART LIST
ASSEMBLY INSTRUCTIONS
-
Step 1: Attach the Thread Bolt(N) to the HB Posters L/R(G) cushion, onto pre-drilled holes and secure by hand.
Then put the Leg(C) with the Footboard(B) by using the Bolt(L), Spring Washer(P), Flat Washer(Q), and Allen Key(S). -
Step 2: Put the Side Rail(D;E) symmetrical. Next put the Support Side Rail(K) them with the by using the Bolt(M), Spring Washer(P), Flat Washer(Q) and Allen Key(S).
-
Step 3: Before performing this step, please loosen the Bolts of the Leg Pillar L/R(F) cushion and Footboard(B), intended to hook metal Rail(D:E) is securely inserted into the Bolts, then the tighten them with the Allen Key(S).
-
Step 4: Put the Headboard(A) up Leg Pillar(F) Next by using the Bolt(M), Spring Washer(P), Flat Washer(Q), and Allen Key(S).
-
Note, in this step only use the hand to turn the bolt.
-
Step 5: Take HB Posters L/R(G) cushion already installed the Thread Bolt(N). Put and align the drill holes to link with Headboard(A), by using the Flat Washer(Q), Spring Washer(P), and Hexagonal Nut(O). At the same time, use the Bolt(M), Spring Washer(P), Flat Washer(Q). Finally, then tighten them with by using use the Open Wrench(R) and Allen Key(S).
-
Step 5: Take use of the Support leg(J) to the hole center of the Slats(H) one by one, and tighten them together.
-
Step 6: Put the Slat clusters on the Side rail(D; E) of the bed to be neat, then tighten them are by Screws(T).
Documents / Resources
|
Polibi RS-677VUB-QB Velvet Upholstered
Bed
[pdf] Instruction Manual
RS-677VUB-QB Velvet Upholstered Bed, RS-677VUB-QB, Velvet Upholstered Bed,
Upholstered Bed, Bed
---|---