RailTrax VersaTrax Bed Anchor For 3rd Gen Tundra Installation Guide
- June 7, 2024
- RailTrax
Table of Contents
RailTrax VersaTrax Bed Anchor For 3rd Gen Tundra
Product Information
Specifications:
- (2) RailTrax Rails
- (4) RailTrax Bolts
- (1) TP50 (Torx Plus 50) 3/8 Drive
- (4) Single Stud L-Series Fittings
Product Usage Instructions
-
Step 1: Remove OEM Bed Bolts
Use a T55 (Torx 55) drive to remove the (4) OEM bed bolts. Refer to Photo 1 for guidance. -
Step 2: Position RailTrax Rails
Place each RailTrax Rail between the bed bolt holes with the lettering facing outwards for proper paracord anchor point usage. See Photo 2 for reference. -
Step 3: Install RailTrax Rails
Insert the (4) RailTrax Bolts through each slot on the RailTrax Rails. Secure the bolts directly to the vehicle frame using the TP50 (Torx Plus 50) drive provided. -
Step 4: Torque Bolts
Ensure each bolt is torqued to 50 ft/lb for proper installation. -
Step 5: Connect L-Series Fittings
Connect or disconnect the L-series tie-down fittings as needed to secure your cargo effectively.
Note: Parts and positions mentioned in the instructions are highlighted in blue in the provided photos.
FAQ
-
Q: Can I use different bolts to secure the RailTrax Rails?
A: It is recommended to use the RailTrax Bolts provided to ensure proper fit and security. -
Q: What is the maximum weight capacity for this product?
A: The maximum weight capacity is X lbs. Please refer to the product specifications for detailed information.
VersaTrax – RailTrax
Install Instructions
Parts Included:
- (2) RailTrax Rails
- (4) RailTrax Bolts
- (1) TP50 (Torx Plus 50) 3/8” Drive
- (4) Single Stud L-Series Fittings
- Step 1: Remove the (4) OEM bed bolts utilizing a T55 (Torx 55) drive (see photo 1)
- Step 2: Position each RailTrax Rail between the bed bolt holes. Ensure the lettering is facing outwards to allow the paracord anchor point to be properly utilized (see photo 2).
- Step 3: Install the (4) RailTrax Bolts through each slot on the RailTrax Rails and secure directly to the frame of the vehicle utilizing the TP50 (Torx Plus 50) drive included.
- Step 4: Torque each bolt to 50 ft/lb.
- Step 5: Connect/disconnect any L-series tie down fittings as required to secure your cargo.
Note: Parts/positions being referenced are highlighted in blue in the photos.