ACTIVE ERA WS-01BU-UK Inflatable Stand-Up Paddle Board with Kayak Conversion Instruction Manual
- June 5, 2024
- ACTIVE ERA
Table of Contents
ACTIVE ERA WS-01BU-UK Inflatable Stand-Up Paddle Board with Kayak Conversion Instruction Manual
INFLATABLE STAND-UP PADDLE BOARD
WITH KAYAK CONVERSION
MODEL WS-01BU-UK
Thank you for choosing to purchase a product from Active Era. Please read the entire manual carefully prior to first use and keep in a safe place for future reference.
Active Era shall not be held responsible for accidents or injuries from the
improper use of the product, failure to follow the instructions given in this
guide or modifications made to the product. To avoid serious injury or death,
follow the safety instructions in this document.
Although every effort has been made to ensure the information contained in
this document is accurate and complete, Active Era shall not be held
responsible for errors or omissions.
SAFETY INSTRUCTIONS
For your safety, use this product only as described in this manual. Any other use not recommended by the manufacturer may result in serious injury or drowning. Read the manual and familiarize yourself with this product before using it on the water in order to ensure safety and prevent accidents. Observe the following safety standards and safe operating practices whenever using this product.
WARNING : Paddle sports can be very dangerous and physically demanding. Users of this product must be aware that this sport may result in injury or drowning. The user of this product acknowledges, understands, and assumes the risks involved in paddle sports.
WARNING : Pay close attention to weather condition and beware of offshore winds, underwater currents, tidal changes and obstacles in the water, which may cause the paddle board to become unstable and can take you away from the coast and/or prevent you from getting back to shore. Check weather forecasts and obtain local knowledge of the marine environment and weather conditions prior to your voyage. Never use this product in stormy weather or in flood conditions. Always take a form of identification with you and inform someone of your paddling route, the time and place of your departure and your intended time and place of arrival.
-
The paddle board is designed for short trips over flat, calm water such as lakes, seas, or rivers in a standing or seated position.
Do not use this product in high waves or for surfing. -
This product is suitable for 1 adult. Do not exceed the maximum weight capacity.
-
Do not overload. An uneven distribution of the load on the board can cause it to tip over and lead to a risk of drowning.
-
This product is not a life saving device. Use only under competent adult supervision.
-
This product is not a toy.
-
This product and the accessories supplied are not designed for use by children age 12 or younger. Do not leave children unattended. Young people between ages of 13 and 17 must use this product under the direct supervision of an adult at all times.
For those aged 13 years and up, an adult must explain all the instructions contained in this document prior to use. -
Learn how to operate this product. Train with a qualified instructor and develop your experience in controlled situations.
-
The product is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge.
-
Do not leave the product unattended near water when not in use.
-
Always wear a PFD (Personal Flotation Device) approved by your local authorities, when using this product on water.
-
Inflate the product as per the instructions provided and to the rated pressure indicated on the product. Do not exceed the recommended maximum pressure as this can result in the board becoming over-inflated and may cause the air chamber to burst.
-
The air inside the board can expand and the board can over-inflate in very hot temperatures or when exposed to direct sunlight. Please check the air pressure and deflate your board as necessary.
-
The valve tightening key is only to be used when the board is deflated. Never use the key to screw or unscrew the valve when the board is inflated. This can cause serious injury.
-
Do not operate the board under the influence of drugs, alcohol, or medication.
-
Dress appropriately for weather and marine conditions and wear a helmet when appropriate; cold water and cold weather can result in hypothermia.
-
For your own safety please attach the leash provided to your calf or ankle when using this product. Secure one end to the D-ring at the rear of the board and securely attach the Velcro strap to your calf or ankle.
-
Ensure you can always exit the board if necessary.
-
Do not paddle alone. Always paddle with an experienced partner when using this product.
-
Do not exceed your paddling ability; be aware of your limitations.
-
Check your equipment prior to each use for signs of wear, leaks, or failure. Do not use the product if there are any signs of damage to the board or any of the accessories supplied.
-
Do not attempt to make alterations to this product or any of the accessories supplied. Doing so may be unsafe and will void your warranty.
-
Keep away and do not insert pins or sharp objects into the board.
-
Do not stand on your board or place heavy items on top when it is lying on the ground as this can damage your fins.
-
Do not use the product in shallow waters as this can cause damage to the board, fins, and paddles.
-
Stay hydrated by packing a water bottle in your bungee compartment.
-
Store your mobile phone in the waterproof dry bag provided. Also, consider packing a whistle or flashlight in case of an emergency.
-
If you are using your board for the first time or after storage, check the air valve and first tighten.
-
The pump supplied is suitable for inflating the Active Era paddle board. Other uses or modification made to the pump are considered non-intended usage and can lead to risk of injury and damages. The pump is not intended for commercial use.
-
The pressure gauge is only suitable for inflating the board and the gauge value should be used for reference purposes only. Do not use as a precision instrument.
-
Dispose of packaging, contents, containers, and products at the end of their life cycle in accordance with local regulations.
SPECIFICATION
- Model: WS-01BU-UK
- Product Dimensions: 320 x 78 x 15cm
- Board Weight: 8.5Kg
- Rider Weight Range: 45-100Kg
- Maximum Weight Capacity: 100Kg
- Max Pressure: 15PSI
- Pump Dimensions: 11 x 25 x 63cm
- Paddle Height Range: 165-208cm
PARTS
- Camera Mount
- Handle
- Bungee Cord
- Footrest Loops
- Centre Handle
- Non-slip Deck Pad
- D-ring for Kayak Seat (x4)
- Valve
- Handle
- Leash D-ring
- Small Fin (x2)
- Centre Fin Slot
- Removable Centre Fin
- Centre Fin Lock
- Pump Hose
- Dual Action Pump
- Leash
- Belt
- Backpack
- Repair Kit*
- Dry Bag
- Multifunctional Paddle
- Footrest
- Kayak Seat
*(including 2 x pvc patches, valve tightening key, glue).
INFLATION & DEFLATION
We strongly recommend that you inflate and deflate your paddleboard once prior
to first use to familiarise yourself with the process. The
inflation of your paddleboard should take 10-15 minutes but can take a little
longer.
Valve
- Cap (twist to unlock)
- Base (partly visible)
- Button
Pump
- Handles
- Pump Footrest
- “INFLATE” Hose Adapter
- Switch Valve
- “DEFLATE” Hose Adapter
- Pressure Gauge
- Hose
- Valve Side Connector
- Pump Side Connector
Note : The pump included in this product is a Dual Action Pump and can be used for inflation and deflation. There are two modes available when inflating your board:
- Dual Action Mode will double the amount of air being pumped into your paddle board. Pumping will get tougher as more air is pumped into the board. To activate Double Action Mode, close the Switch Valve (see image below).
- Single Action Mode will reduce the amount of air being pumped into the board. In Single Action Mode, it is easier to pump air so we recommend that this is activated when your board is close to full inflation. To activate Single Action Mode, remove the Switch Valve (see image below).
Inflation
-
Find a smooth, flat and clean surface with plenty of room to unfold your board. Lay it, unfolded, with the valve facing up and the two small fins facing down.
-
Connect the pump to the hose on the “INFLATE” Hose Adapter (labelled on the top of the pump). (1)
-
Unscrew the valve cap.
-
Put the button in the “UP” position. (2)
NOTE : when inflating or deflating your paddleboard, push (a) and twist (b) the valve button to open or close the valve. -
Insert valve side connector into valve and secure by turning clockwise. (3)
-
Pump until you reach the required pressure. We recommend starting with Dual Action Mode and changing to Single Action Mode as the pumping becomes difficult.
WARNING : The correct range for this board is 7.5 – 15PSI (0.5-1bar). Do not exceed the maximum recommended pressure. -
Remove connector and replace valve cap when using the board (4)
NOTE : The board should feel solid when fully inflated. Please do not apply sustained pressure to the board when on land as this may damage the small fins.
Deflation
-
Find a smooth, flat and clean surface with enough room for your inflated board. Lay it with the valve facing up and the two small fins facing down.
-
Unscrew the valve cap.
-
Put the button into the “DOWN” position. Your board will automatically start to deflate. Please ensure your face and body are away from the valve. (1)
NOTE : when inflating or deflating your paddleboard, push (a) and twist (b) the valve button to open or close the valve. -
Once most of the air has escaped, connect the hose to the “DEFLATE” Hose Adapter on the pump (labelled on the top of the pump). (2)
-
Insert the valve side connector into valve and tightly secure by turning clockwise. (3)
-
Pump the remaining air out of the board using Single Action Mode. (4)
ASSEMBLY
Removable Centre Fin
We recommend attaching the centre fin if you are going to use the board in deep waters like the sea or a lake. Avoid using the centre fin in shallow waters or white water as you risk deteriorating it.
- Lay your board face down (with the valve facing the floor) on a smooth, flat, and clean surface (preferably when inflated).
- Check that the fin slot is clear of any obstruction. Slide the Centre Fin into the designated slot, ensuring that the fin is pointing to the back of the board. (1)
- Insert Lock Pin to secure the Fin. (2)
Paddle
The paddle assembly will differ slightly depending on whether you use your board for paddle boarding or kayaking. For kayaking, please see the KAYAK CONVERSION section below.
Your paddle is a multifunctional paddle composed of 4 sections:
- Blade
- Middle Shaft
- T-bar
- Additional Blade
- Connect the Blade (1) to the Middle Shaft (2) and then to the T-bar (3).
- Unclip the fastener to adjust the paddle to the required size from 165 to 208cm.
We recommend the paddle height to be about 10cm higher than rider’s height.
Note: Make sure the Active Era logo on the blade is facing backwards when paddling.
Leash
For your own safety, please securely attach the leash provided to your calf or
ankle when using this product.
Secure one end to the D-ring at the rear of the board and securely attach the
Velcro strap to your calf or ankle.
Camera Mount
Your paddleboard comes with a camera mount. Simply attach your camera to the mount ready for use.
Note: Please ensure the camera is securely attached to prevent loss or damage. Active Era take no responsibility for loss of cameras.
KAYAK CONVERSION
Kayak Seat
For comfort, balance & performance, the kayak seat should be attached at the rear of the board, just behind the central handle.
- Securely attach the inner two straps to the back D-rings. (1)
- Securely attach the outer two straps to the front D-rings (pulling the back rest forward into place). (2)
- Tighten all straps so that the seat is both comfortable and firmly upright.
Footrest
Insert each end of the footrest into the footrest loops. Check that it is securely in place.
Paddle
When Kayaking, the paddle should be assembled in a slightly different way to when paddle boarding.
- Connect Blade (1) to the Middle Shaft (2).
- Connect the other end of the Middle Shaft (2) to the Additional Blade (4).
Note : Make sure the Active Era logo on the blades is facing backwards when paddling.
USER TIPS
Holding your board
Carry you board using the centre handle by holding it sideways, under your arm, and with the fins pointing toward your body.
Note : Grip the board tightly as wind can catch it. Stand away from others to avoid injury when the wind picks up.
Standing on your board
We recommend kneeling on your board before standing.
Slowly stand up, one foot at a time, in the centre of the board. Your feet
should be parallel to each other and in line with the centre handle
– about shoulder width apart.
Keep a slight bend in the knees and your core centred over the board.
Holding your paddle when paddle boarding
- A common mistake when paddle boarding is to hold the paddle incorrectly.
- Place one hand just above the middle of the paddle. Grip the top of the paddle with your other hand (seen in picture below).
- When holding the paddle above your head, both arms should have a slight bend.
- When using the paddle, always ensure the paddle base is pointing forward with the Active Era logo on the blade facing backwards.
CLEANING & STORAGE
CAUTION : After use always clean your paddle board to prevent it from being damaged by sand, salt water or sunlight. Do not use any abrasive cleaners or solvents, as this will damage the paddle board. Do not store this product in direct sunlight. Do not store this product when wet.
- Remove leash, centre fin, and any other accessories you attached.
- Clean the board and accessories with a soft sponge and fresh water. Do not immerse accessories such as the pump in water.
- Ensure the board and all accessories are completely dry before packing away and storing, otherwise mould may develop, or colour may transfer onto your board.
- Ensure that no sand or gravel remains inside the board, the hull and the inner chambers, otherwise this could result in abrasion or even punctures to the board during storage.
- Deflate your board following instructions found earlier in this manual.
- Tightly roll it up starting from the opposite end from the valve to make sure you remove all the remaining air.
- Ensure the Valve Button is in the “UP” position to avoid any dust entering the board and then close the Valve Cap.
- Place board and accessories into the provided bag.
- Store in a clean, dry place away from direct sunlight. Place out of reach of children.
TROUBLESHOOTING
If you have any trouble with our paddleboard, here is some information that may be able to help.
WARNING : Perform all of your repairs outside or in a well-ventilated area. Wear protective gloves/protective clothing/eye protection/face protection to avoid inhaling glue vapours or contact with skin, mouth or eyes. Keep the glue away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Keep all repair materials (glue, solvents, etc.) out of reach of children. Read all WARNINGS and safety advise listed on the Paddle Board Repair Glue (Polyurethane Resin Adhesive) container prior to use.
CAUTION : The repairs on the welds must not be glued. Only the manufacturer of the board can perform repairs on the welds themselves.
If any problem persists, please contact our customer service.
One Retail Group
Ryland House, 24a Ryland Road, London, NW5 3EH, UK
EU Authorised Representative: Brandrep Limited
The Black Church, St Mary’s Pl N, Dublin, D07 P4AX, Ireland
© Copyright 2021
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>