Sanitaire SC600 and SC800 Series Commercial Vacuum Cleaner Owner’s Manual

SC600 and SC800 Series Commercial Vacuum Cleaner
Owner’s Manual

Commercial vacuum cleaner
OWNER’S GUIDE
Series SC600 and SC800
Shake Out Bag models

What’s in the carton

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER
When using an electrical appliance, basic precautions should be observed, including the following:

WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:

• Connect to a properly grounded outlet only. See grounding instructions. Do not modify the three-prong grounded plug.
• Do not leave the appliance when it is plugged in. Unplug from the outlet when not in use and before servicing.
• Do not use it outdoors or on wet surfaces.
• Do not use a motorized nozzle on wet surfaces.
• Do not allow to be used as a toy. Close attention is necessary when used by or near children.
• Do not use for any purpose other than described in this user guid
• Do not use with damaged cord or plug. If the appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water; do not attempt to operate it, have it repaired at an authorized service center.
• Do not pull or carry by cord, use the cord as a handle, close door on the cord, or pull the cord around sharp edges or corners. Do not run the appliance over the cord. Keep the cord away from heated surfaces.
• Do not unplug by pulling on the cord. To unplug, grasp the plug, not the cord.
• Do not handle plugs or appliances with wet hands.
• Do not put any objects into openings. Do not use any opening blocked; keep openings free of dust, lint, hair, and anything that may reduce airflow.
• Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts of the appliance and its accessories.
• Turn OFF all controls before plugging or unplugging the appliance.
• Use extra care when cleaning on stairs.
• Do not use to pick up flammable or combustible materials (lighter fluid, gasoline, kerosene, etc.) or use in areas where they may be present.
• Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
• Do not use without a dust bag and/or filters in place.
• Use only three-wire SJT extension cords that have three-prong grounding plugs and grounding receptacles that fit the appliance’s plug.
• Make sure your extension cord is in good condition and is the correct size for your appliance.
• Maintain Appliance With Care – Inspect extension cords periodically and replace if damaged.
• Risk of injury from moving parts. The motor may start unexpectedly. Unplug before cleaning or servicing.
• Do not turn your vacuum ON until you are familiar with all instructions and operating procedures. Keep the appliance on a level surface.
• Do not use appliances in an enclosed space filled with vapors given off by oil-based paint, paint thinner, some moth-proofing substances, flammable dust, or other explosive or toxic vapors.
• Do not use to pick up toxic material (chlorine bleach, ammonia, drain cleaner, etc.)
• Do not pick up hard or sharp objects such as glass, nails, screws, coins, etc.
• Plastic film can be dangerous. To avoid the danger of suffocation, keep away from children.

SAVE THESE INSTRUCTIONS
THIS MODEL IS FOR COMMERCIAL USE
  WARNING
Improper connection of the equipment-grounding conductor can result in a risk of electrical shock. Check with a qualified electrician or service person if you aren’t sure if the outlet is properly grounded. DO NOT MODIFY THE PLUG. If it will not fit the outlet, have a proper outlet installed by a qualified electrician. This appliance is designed for use on a nominal 120-volt circuit and has a grounding attachment plug that looks like the plug in the drawing to the right. Make certain that the appliance is connected to an outlet having the same configuration as the plug. No plug adapter should be used with this appliance.

GROUNDING INSTRUCTIONS

This appliance must be connected to a grounded wiring system. If it should malfunction or break down, grounding provides a safe path of least resistance for electrical current, reducing the risk of electrical shock. The cord for this appliance has an equipment-grounding conductor and a grounding plug. It must only be plugged into an outlet that is properly installed and grounded in accordance with all local codes and ordinances.
CAUTION
Assemble the vacuum cleaner FULLY before using it. With brush roll on, do not allow the vacuum to sit in one location for an extended period of time, as damage to the floor can result.

How to assemble

1. Slide the upper handle and the lower handle together so the handle bolt holes are positioned as shown in the detailed drawing. Insert a 2-part bolt in the center of the handle and tighten. Hold assembled handle so the handle curves away from the vacuum. Place the lower handle into the handle socket at the rear of the vacuum. Align holes. Insert a 2-part bolt and tighten using a screwdriver.
2. Pull the spring on the electrical cord upward toward the top of the handle. Insert the lower half of the spring into the upper cord hook as shown. Snap the hook into the upper handle (Fig. 4).
3. Insert the power cord into the lower cord hook. Snap into the lower handle. Pull on the cord to tighten but leave enough slack near the base so the cord is not strained when the handle is lowered. Wrap the cord around the two cord hooks and fasten the plug to prevent unwinding.
4. Insert the bag adapter clip on the bottom of the bag collar into the bag adapter retainer.
5. Push the bag collar up and forward so the locator lug slides into the slot. Turn the cam latch to lock the bag onto the rivet. Loop the spring on the top of the bag onto the bag support on the back of the upper cord hook.

How to operate
Power cord
• Attach the extension cord to the power cord and secure it with the cord lock provided (on some models).

Handle adjustment

• With the tip of the foot press down the handle release located at the left rear side of the cleaner. Move the handle and adjust it to the desired position.
• Step on the handle release a second time to allow the handle to lay flat for cleaning under low furniture.

Vacuum cleaner height settings
Warning: Avoid injury. Keep loose clothing, hair, fingers, and all other parts of the body away from any moving part (such as the revolving brush). Turn the cleaner off and unplug it before changing the height.

• With the power cord unplugged, adjust the base to the highest setting with a six-position adjustment knob.
• Plug in the vacuum, step on the power switch, and turn on the vacuum. Lower setting one notch at a time until you hear bristles touching the carpet. This should be a noticeable sound change.
  Recommended| setting| Carpet height
  ---|---|---
  Position   1-2| | Low pile
  Position  3-4| | Medium pile
  Position  5-6| | High pile

When finished using the vacuum, wrap the cord around the cord wrap for storage. Store the vacuum indoors in a dry location in an area where the appliance is not likely to get damaged.

How to empty Shake Out Bag

1. Slide the clamp away from the top of the bag.
2. Turn the cam latch to release the bag. Hold the bag by the collar (bottom) and shake. Reinsert the bag adapter into the bag adapter retainer.
3. Push the bag collar up and forward so the locator lug slides into the slot. Turn the cam latch to lock the bag onto the rivet.

How to maintain

How to replace a worn belt
Warning: Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.

1. Release the cam locks and remove the bottom plate. Pull up the belt to rotate it off of the motor pulley. Lift up on the brush roll and remove the worn belt. Place a new belt around the brush roll. Align the brush roll pulley with the belt guide (Fig. 3).

2. Ensure the rubber end cap cover is installed correctly (Fig. 4A). Align end caps with slots in a cleaner base. Push the brush roll into the base.

3. Place the lower side of the belt into the belt guide and pull to stretch the belt around the left side of the motor pulley. Rotate the pulley to secure the belt into the groove. Replace the bottom plate and secure it with the cam locks.
   How to replace bristle strips (some models )

4. Remove the rubber end cap (A) from one end. Unscrew locknut (B). Remove end cap (C) – sleeve bearing brush roll includes a shaft washer not shown. Remove bearing retainer (D). Push shaft (E) through the opposite end. Pull out worn bristle strip (F) with pliers. Slide in a new bristle strip of the same length (rounded end first.)
   Fit the track on either side of the bristle strip into the brush roll slot. Replace the second strip from the opposite end of the brush roll.

5. Replace the shaft. Align indentation on bearing retainer with bristle strip on both ends of the brush roll. Reassemble the remainder of the brush roll and secure it into the base (Fig. 2).

CAUTION
Turn off the switch and unplug the electrical cord before maintenance.
Important: Improper installation of the brush roll or brush roll belt could cause carpet or cleaner damage.
CAUTION
Make sure the vacuum cleaner is turned off and unplugged.

How to clear a blockage

Dust bag may be full
Check the dust bag if full. Refer to page 4.
Check brush roll for debris

• If the dust bag is not full, check the bottom of the cleaner and the brush roll.
  • Turn the cleaner upside down. Clip strings with scissors.
  • If necessary, release the cam locks and remove the bottom metal plate. Clear debris around the brush roll.
  How to clear clogs in the fan chamber (some models)

• If there is not a clog around the brush roll, there may be a clog in the clear fan chamber. If you see a clog, release two cam locks and remove the bottom plate.
  Remove the two screws to release the clear fan cover.
  • Use a hanger to help release the clog around the fan, but do not remove the fan.

Any other maintenance or servicing not included in this manual should be performed by an authorized service representative.

Problem-solving

CAUTION: Always unplug vacuum cleaner before servicing.

Motor will not start| Turn power switch to on.
Push plug securely into outlet.
Try another outlet.
Vacuum cleaner does not clean| Adjust carpet height setting to lower position.
Check for clogs that restrict the airflow.
Check for worn or broken belt and replace if necessary.
Vacuum cleaner is hard to push| Adjust carpet height setting to higher position.
There is a clog| Remove the bottom metal plate. Check for clog in base and / or brushroll. See above.
There is a burning smell| The belt may be damaged or something may be caught in the brushroll.
Check brushroll and remove any obstruction.
Replace belt.
There is dust leaking| Make sure clamp on bag is secure. Refer to pg. 4.

WARRANTY

This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact Sanitaire® Customer Service by E-mail, telephone or regular mail as described below.
Limited Two-Year Warranty
Subject to the EXCEPTIONS AND EXCLUSIONS identified below, upon receipt of the product Sanitaire will repair or replace (with new, refurbished, lightly used, or remanufactured components or products), at Sanitaire’s option, free of charge from the date of purchase by the original purchaser, for two years any defective or malfunctioning part. See the information below on “If your Sanitaire product should require service”. This warranty does not apply to fans or routine maintenance components such as filters, belts, or brushes. Damage or malfunction caused by negligence, abuse, neglect, unauthorized repair, or any other use not in accordance with the user guide is not covered.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
EXCEPTIONS AND EXCLUSIONS FROM THE TERMS OF THE LIMITED WARRANTY
THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES, EITHER ORAL OR WRITTEN. ANY IMPLIED WARRANTIES WHICH MAY
ARISE BY OPERATION OF LAW, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED TO THE TWO-YEAR DURATION FROM THE DATE OF PURCHASE AS DESCRIBED ABOVE.
Some states do not allow limitations on how long an implied warranty lasts so the above limitation may not apply to you.
NOTE: Please keep your original sales receipt. It provides proof of the date of purchase in the event of a warranty claim.

SERVICE INFORMATION

If your Sanitaire product should require service
You will find the nearest Sanitaire Authorized Service Center in your area online at sanitairecommercial.com under service locator or contact Sanitaire Customer Service.
If you need information about repairs or replacement parts, or if you have questions about your warranty, contact Sanitaire Customer Service.

Website: www.sanitairecommercial.com
Call: Sanitaire Customer Service
1-800-800-8975

Order genuine Sanitaire ® replacement parts
Visit www.sanitairecommercial.com
or call 1-800-800-8975

Length of extension cord

| 25 feet| 50 feet| 100 feet| 150 feet
110V-120V| 7.5 meter| 15.25 meter| 30.5 meter| 45.7 meter
Amps| A.W.G. wire size
0-6| 18| 16| 16| 14
7-10| 18| 16| 16| 14

Extension cords
When using an extension cord with your unit, refer to the following table to determine the required A.W.G. wire size. Make sure the extension cord is in good condition and the correct size. Use only three-wire extension cords that have three-prong grounding plugs and grounding receptacles that accept the appliance’s plug.
WARNING: To reduce the risk of personal injury due to a loose electrical connection between the appliance’s plug and extension cord, firmly and fully attach the appliance plug to the extension cord.
Periodically check the connection while operating to ensure it is fully attached. Do not use an extension cord that provides a loose connection. A loose connection may result in overheating, and fire, and increases the risk of burning. To reduce the risk of disconnection of the appliance cord from the extension cord during operation, secure the extension cord to the appliance plug using the cord lock as shown in the assembly instructions.
Maintain appliance with care – Inspect extension cords periodically and replace if damaged.

BISSELL part no.
1632026 (5/2022)
Sanitaire®
© BISSELL Homecare, Inc.
Printed in Mexico
1-800-800-8975 19

References

• Best Commercial Grade Vacuum Cleaners | Sanitaire Commercial
• Best Commercial Grade Vacuum Cleaners | Sanitaire Commercial

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>