imation IMCD100 CHARGING DOCK User Guide
- June 5, 2024
- imation
Table of Contents
imation IMCD100 CHARGING DOCK
imation Charging Dock Quick Start Guide
Thank you for purchasing Imation Charging Dock. Please refer below for installation guide of proper installation and warranty policy
The components
How to connect
- Cable connection -Connect imalion charging dock to ! the computer with an enclosed USB Type-C cable.
- Replacing a charging module – Remove the charging cap at the bottom of the mouse and put it on the enclosed charging cap in the same pace.
- Charging Mouse – Place the mouse on imation Charging Dock properly.
- Reducing Delays – Plunge! the USB receiver of ! the mouse on the USB port on imation Charging Dock.
- Charging confirmation -If ! the mouse is charging correclly, ! the LED of imalion Charging Dock will be red.
Compatibilily
G403 PRODIGY. G502.
G703, G903. G703 HERO. G903 HERO.
WIRELESS
Please note imalion Charging Dock is compatible for only wireless rechargeable
mouse.
LED STATIJS
Standby Mode – White Charging Mode – Red Complete Charging – White
Precautions
1 . Do not strike, bend, drop, wet or apply excessive force to imation
Charging Dock.
This may cause data losses or damages to the product
2. Do not disassemble or damage Imation Charging Dock. If imation Charging
Dock has been disassembled by user. all warranties will be void.
Warranty Policy
imation Charging Dock covered by 1 year limned warranty from the original
purchase date. Pursuant to !The terms of imalion warranty policy. imation will
provide proper warranty service or product fail under normal use. For !The
produces !That are out–of-warranty period hereunder, imation may refuse to
provide any warranty service.
Product customer service will be varied by region or country, If the product
service s not available, please contact resellers.
Warranty Limitations
The warranty s1a1ed herein does not apply if any product failure caused by
- Act of improper use such as prolonged exposure to
- Malfunction of other equipment
- Acts of nature
- Defects or damages from moving or dropping alter purchase
- Damaged connector or cable – Operational Humidity: RH 7Cflo I Temperature : 0–.. 70t
Warning and Precautions
imation is not responsible for any cost caused by defects or damages of
products from misuse or neglect.
Product Specification
| Rated Input | 5V = 0.5A |
|---|---|
| interface | USB 2.0 Type C |
| Operational Temperature | o·c to 7o•c |
| Physical Dimension(LxWxH) | 62.5mm x 45.5mm x 52mm |
| Weight | 70g |
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
My changes or modifications (including the antennas) to this device that are not expressly approved by the manufacturer may void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide
reasonable protection against harmful interference in a residential
installation This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause ham, full interference to radio communications,
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void your authority to operate the equipment under FCC rules.
Corporation I www.imation.com