STAR WARS 2140423 Mandalorian Razor Crest Vehicle Instruction Manual
- June 5, 2024
- STAR WARS
Table of Contents
STAR WARS 2140423 Mandalorian Razor Crest Vehicle Instruction Manual
BATTERY SAFETY INFORMATION
- DO NOT MIX OLD AND NEW BATTERIES.
- DO NOT MIX ALKALINE, STANDARD (CARBON-ZINC), OR RECHARGEABLE (NICKEL-CADMIUM) BATTERIES.
- ONLY BATTERIES OF THE SAME OR EQUIVALENT TYPE AS RECOMMENDED ARE TO BE USED.
- BATTERIES ARE TO BE INSERTED WITH THE CORRECT POLARITY.
- EXHAUSTED BATTERIES ARE TO BE REMOVED FROM THE PRODUCT.
- REMOVE BATTERIES IF PRODUCT IS TO BE LEFT UNUSED FOR A LONG TIME.
- THE SUPPLY TERMINALS ARE NOT TO BE SHORT-CIRCUITED.
- NON-RECHARGEABLE BATTERIES ME NOT TO BE RECHARGED.
- RECHARGEABLE BATTERIES ARE TO BE REMOVED FROM THE PRODUCT BEFORE BEING CHARGED.
- RECHARGEABLE BATTERIES ARE ONLY TO BE CHARGED UNDER ADULT SUPERVISION.
- DISPOSE OF BATTERY(IES) SAFELY.
- DO NOT DISPOSE OF THIS PRODUCT IN A FIRE. THE BATTERIES INSIDE MAY EXPLODE OR LEAK.
- BATTERIES SHOULD BE CHARGED BY ADULTS ONLY.
SAFETY PRECAUTIONS
REMEMBER TO AVOID WATER, HEAT, SAND AND HIGH IMPACT!
- KEEP VEHICLE AWAY FROM WET SURFACES OR RAIN.
- AVOID RUNNING ON THICK CARPETS OR DUSTY FLOORS.
- AVOID COLLISIONS ON HARD SURFACES.
- KEEP VEHICLE AWAY FROM SANDY OR DUSTY AREAS.
- DO NOT OPERATE YOUR VEHICLE ON THE STREETS!
WARNING:
CHOKING HAZARD —Small parts Not for children under 3 years.
VEHICLE OPERATION
ANY OF THE FOLLOWING CONDITIONS MAY INTERFERE WITH THE BEHAVIOR AND FUNCTION. THE TRANSMITTER SIGNALS CAN EASILY BE INTERRUPTED. IMPROPER HANDLING MAY HAMPER THE PERFORMANCE OF THE VEHICLE.
CONTENTS
- VEHICLE
- CONTROLLER
- INSTRUCTION GUIDE
BATTERY INSTALLATION
VEHICLE
**CONTROLLER
**
USING THE CONTROLLER
HOW TO PAIR THE CONTROLLER TO THE VEHICLE BEFORE PLAY
HOW TO PAIR
- INSERT BATTERIES (CAR AND CONTROLLER).
- TURN CAR & CONTROLLER SWITCH TO “ON.”
- PRESS ANY BUTTON ON THE CONTROLLER FOR 2 TO 3 SECONDS.
- PAIRING SHOULD BE SUCCESSFUL.
- IF YOU NEED TO PAIR MORE CARS WITH SEPARATE CONTROLLERS AT THE SAME TIME, THEY MUST BE PAIRED 3 METERS APART FROM EACH OTHER.
HOW TO RESET PAIRING
- TURN CAR & CONTROLLER SWITCH TO “OFF.”
- TURN CAR & CONTROLLER SWITCH TO “ON” AFTER 2 TO 3 SECONDS.
- PRESS ANY BUTTON OF THE CONTROLLER FOR 2 TO 3 SECONDS.
- PAIRING SHOULD BE SUCCESSFUL.
FORWARD
PRESS TOP ARROW BUTTONS “1” AND “3” AT THE SAME TIME TO WHEELIE / MOVE
FORWARD.
REVERSE
PRESS BOTTOM ARROW BUTTONS “2” AND “4” AT THE SAME TIME TO REVERSE.
SPINNING
PRESS ARROW BUTTONS “1” AND “4” TO MOVE FORWARD / SPIN LEFT.
PRESS ARROW BUTTONS “2” AND “3” TO MOVE FORWARD / SPIN RIGHT.
TURNING
-
PRESS ARROW BUTTON “1” TO MOVES FORWARD/TURNS LEFT.
PRESS ARROW BUTTON “3” TO MOVES FORWARD/TURNS RIGHT.
-
PRESS ARROW BUTTON “2” TO MOVES IN REVERSE/TURNS LEFT.
-
PRESS ARROW BUTTON “4” TO MOVES IN REVERSE/TURNS RIGHT.
TRUSTER ASSEMBLY
ADULT ASSEMBLY REQUIRED
VEHICLE BODY
Align thrusters with vehical body
ANGLE TRUCTER “1” AND “2” AND SNAP INTO THE BODY TO SECURE AND LOCK.
STAGE
| CONCEPT
---|---
DESIGNER|
SILVIA ORDONEZ
DATE:
| MAY 13, 2021
DIMENSIONS:|
23.375″W X 8.26″H
UPLOADED TO FACTORY SERVER:
|
23.375″W X 8.26″H
PACKAGING CHECK LIST
- CORRECT FINAL DIMENSIONS
- CORRECT AGE GRADE
- CORRECT WARNING LABEL SIZE
- CORRECT LEGAL COPY/ UPC / ITEM#
- SPELL CHECK
- IMAGES IN HIRES
- BATTERY INFORMATION / 1M
FCC STATEMENT
CAUTION
CHANGES OR MODIFICATIONS TO THIS UNIT NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
NOTE: THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS
FOR A CLASS B DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE
LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL
INTERFERENCE IN A RESIDENTIAL INSTALLATION. THIS EQUIPMENT GENERATES, USES AND
CAN RADIATE RADIO FREQUENCY ENERGY AND, IF NOT INSTALLED AND USED IN
ACCORDANCE WITH THE INSTRUCTIONS, MAY CAUSE HARMFUL INTERFERENCE TO RADIO
COMMUNICATIONS.
HOWEVER, THERE IS NO GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN A
PARTICULAR INSTALLATION. IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO
RADIO OR TELEVISION RECEPTION, WHICH CAN BE DETERMINED BY TURNING THE
EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED TO TRY TO CORRECT THE
INTERFERENCE BY ONE OR MORE OF THE FOLLOWING MEASURES:
- REORIENT OR RELOCATE THE RECEIVING ANTENNA.
- INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER.
- CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED.
- CONSULT THE DEALER OR AN EXPERIENCED RADIO/TV TECHNICIAN FOR HELP.
THIS DEVICE CONTAINS LICENSE-EXEMPT TRANSMITTER(S)/RECEIVER(S) THAT COMPLY WITH INNOVATION, SCIENCE AND ECONOMIC DEVELOPMENT CANADA’S LICENSE-EXEMPT RSS(S). OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
- THIS DEVICE MAY NOT CAUSE INTERFERENCE.
- THIS DEVICE MUST ACCEPT ANY INTERFERENCE. INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION OF THE DEVICE.
** THIS DEVICE AND ITS ANTENNA MUST NOT BE CO-LOCATED OR OPERATING IN CONJUNCTION WITH ANY OTHER ANTENNA OR TRANSMITTER.
THIS RADIO COMMUNICATION DEVICE COMPLIES WITH ALL THE REQUIREMENTS OF INDUSTRY CANADA STANDARD RSS-210.
REQUIRES 4 X AA (LR6) AND 1 X 9V (6LR61) ALKALINE BATTERIES (NOT INCLUDED).
BATTERIES OR BATTERY PACKS MUST BE RECYCLED OR DISPOSED OF PROPERLY. WHEN THIS
PRODUCT HAS REACHED THE END OF ITS USEFUL LIFE IT SHOULD NOT BE DISPOSED OF
WITH OTHER HOUSEHOLD WASTE.
THE WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT REGULATIONS REQUIRE IT TO BE
SEPARATELY COLLECTED SO THAT IT CAN BE TREATED USING THE BEST AVAILABLE
RECOVERY AND RECYCLING TECHNIQUES. THIS WILL MINIMIZE THE IMPACT ON THE
ENVIRONMENT AND HUMAN HEALTH FROM SOIL AND WATER CONTAMINATION BY ANY
HAZARDOUS SUBSTANCES, DECREASE THE RESOURCES REQUIRED TO MAKE NEW PRODUCTS AND
AVOID USING UP LANDFILL SPACE. PLEASE DO YOUR PART BY KEEPING THIS PRODUCT OUT
OF THE MUNICIPAL WASTE STREAM! THE “WHEELIE BIN” SYMBOL MEANS THAT IT SHOULD
BE COLLECTED AS “WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT.” YOU CAN RETURN AN
OLD PRODUCT TO YOUR RETAILER WHEN YOU BUY A SIMILAR NEW ONE. FOR OTHER
OPTIONS, PLEASE CONTACT YOUR LOCAL COUNCIL.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND ) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
MEETS CPSC SAFETY REQUIREMENTS
MADE IN CHINA
SUPPORT
MANUFACTURED BY
JAM’N PRODUCTS INC.4199 BANDINI BLVD. SUITEA LOS ANGELES.CALAFORNIA 90058
WWW.JAMNPRODUCTS.COM
IF YOU HAVE QUESTIONS OR DIFFICULTY OPERATING THIS TOY
DO NOT RETURN IT TO THE STORE
CALL US TOLL-FREE: 1-855-886-JAMN (5266)
MONDAY – FRIDAY BETWEEN 9:00 AM – 5:30 PM PACIFIC STANDARD TIME OR EMAIL US
AT:
CUSTOMERSERVICE@JAMNPRODUCTS.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>