HAMPTON BAY 50313 Rock Pillar Solar Path Light User Guide

USE AND CARE GUIDE
ROCK PILLAR SOLAR PATH LIGHT Questions, problems, missing parts? Before returning to the store,
call Customer Service
8 a.m. – 6 p.m., EST, Monday-Friday
1-830-249-1200
CustomerService@Creative-prc.us
Retain this manual for future use

Safety Information

WARNING: Your solar light may not function in temperatures below -4ºF (-20ºC) or above 140ºF (60ºC).
CAUTION: Use a rechargeable battery only. Recycle or dispose of batteries properly.
CAUTION: Do not open, short circuit, or mutilate batteries as injury may occur.

Warranty

ONE-YEAR LIMITED WARRANTY
WHAT IS COVERED
The manufacturer warrants this product to be free of defects in material and workmanship for a period of one (1) years from the date of purchase. This warranty only applies to the original consumer purchaser and only to products used in normal use and service. The manufacturer’s only obligation and your exclusive remedy is the repair or replacement of the product at the manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, accident, modification, alteration, neglect, or mishandling. Proof of purchase and evidence of manufacturer’s date coding must accompany all warranty claims. The manufacturer’s date coding is printed and adhered to for each product.

WHAT IS NOT COVERED
This warranty does not apply to products that are found to have been improperly installed, set up, or used in any way not in accordance with the instructions supplied with the product. This warranty does not apply to a failure of the product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation. Batteries supplied with this product are not included in this warranty. This warranty shall not apply to the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and specially disclaims any warranty, whether express or implied, of fitness for a particular purpose, other than the warranty contained herein. This warranty does not cover consequential or incidental loss or damage, including but not limited to any labor/expense costs involved in the replacement or repair of the product.
Contact the Customer Service Team at 1-830-249-1200 or CustomerService @Creative-prc.us

Pre-Installation

PLANNING INSTALLATION
Ensure the mounting location for your solar stake light allows the solar panel to receive direct sunlight. Do not locate the product in shaded areas as this will significantly reduce performance.
Position the solar stake light such that during evening hours the ambient light from other light sources does not affect the photosensor built into the solar panel. High ambient light levels can cause the lamp to turn off during evening hours

NOTE: The solar light is equipped with a photosensor that turns the unit on at dusk and off at dawn. Ambient light can affect the operation of the photosensor.

TOOLS REQUIRE

PACKAGE CONTENT

Installation

NOTE: Do not use a hammer. If the ground is hard, use water to soften it.
NOTE: Prior to using, set the AUTO/OFF switch located on the back of the solar box to the AUTO position and allow it to charge on a full sunny day

• Refer to the below-left illustration, remove the top cap and lens assembly (A & B) from the lamp body (C). Pull out the ground stake (D) packed inside the lamp body (C).
• Insert the ground stake (D) firmly into the ground at the installation location. If the ground is too hard, soak the ground with water to soften the ground or drive a metal rod or screwdriver into the ground to create a hole for the ground stake assembly.
• Place the lamp body (C) over the ground stake (D).
• Insert the top cap and lens assembly (A & B) into the lamp body (C).

Maintenance

Battery replacement

NOTE: Use one AA size, 600mAh, 1.2V Nickel Metal Hydride rechargeable battery. For best performance, replace with a Nickel Metal Hydride rechargeable battery annually.
IMPORTANT: Dispose of the battery in accordance with local, state, and federal regulations.
IMPORTANT: When storing any solar product for an extended period of time, remove the batteries. Storing any solar product without regular recharge or removal of batteries could cause permanent damage to the rechargeable batteries.

• Rotate counterclockwise and remove the top cap (A) from the lens (B).
• Unscrew the bottom plate (F) from the top cap (A) and remove it.
• Remove the old battery (E). Replace with a new AA size, 1.2V Nickel Metal Hydride rechargeable battery – The recommended replacement battery capacity should be 600~800mAh.
• Replace the bottom plate (F) with the four screws, and then replace the top cap (A) with the lens (B).

Care and Cleaning

Periodic cleaning of the solar panel and glass housing is quick and easy:

• The solar panel should be cleaned periodically with a damp cloth to help maintain optimum performance.
• Do not use any cleaners with chemicals, solvents, or harsh abrasives.

Troubleshooting

the solar light is located in an area where it can receive the maximum amount of full, direct sunlight every day. Keeping the solar panel clean is equally important to ensure maximum charging performance.
The battery is reaching the end of its useful life.| Replace the old battery with a Nickel Metal Hydride (Ni­MH) rechargeable battery.
The solar light does not turn on at night.| Your solar light is equipped with an AUTO/OFF switch on the back of the solar box. This switch must be set to AUTO prior to use.| Prior to use, check that the unit has been set to the AUTO position and allowed to charge on a full sunny day.
The solar light is installed close to other light sources, which may keep the solar light from turning on at night automatically.| Relocate the fixture or eliminate other light sources.

References

• Your New Address on the Internet!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>