TENNANT T290 Walk Behind Floor Scrubber User Guide
- June 5, 2024
- TENNANT
Table of Contents
TENNANT T290 Walk Behind Floor Scrubber
This guide is intended for quick consultation only and does not replace the
user and maintenance manual.
Before using the machine, read the user and maintenance manual contained in
the machine’s packaging thoroughly and strictly follow all the instructions.
PREPARATION & OPERATION
ATTACHING/REMOVING THE BRUSHES
Attaching the brush: rest the brush on the floor in front of the machine and
centre it with the guard. Lower the head and operate the brush/drive lever
repeatedly until the brush automatically engages on the flange hub. If the
operation is not successful, repeat by pressing on the lever again and
repeating the centring.
Removing the brush: raise the machine head by pushing the head lift pedal down
and then to the right and operate the brush/drive lever repeatedly. After
operating the lever a few times, the brush is released and falls to the
ground.
DAILY MAINTENANCE
REPLACING THE SQUEEGEE BLADES
Open the clip (Ref. 1).
- Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting them.
- Remove the blade.
- Reuse the same blade by reversing the edge in contact with the floor until all four edges are worn out, or replace with a new blade, fitting it onto the screws on the body of the squeegee.
- Reposition the two blade pressing devices by centering the wider part of the slots on the squeegee body fastening pins, then push the blade pressing devices inwards.
- Close the hook again.
- Replace the squeegee on its support, following the instructions described previously.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>