SLEIPNER Thruster SHP Hudraulic User Manual

SLEIPNER Thruster SHP Hudraulic

Failure to follow the considerations and precautions can cause serious injury, damage and will render all warranties given by Sleipner Motor as VOID.

General Operation Considerations and Precautions Guidelines

For the operation of thrusters

Never use thrusters when close to objects, persons or animals in the water. The thruster will draw objects into the tunnel and the rotating propellers. This will cause serious injuries and damage the thruster.
Always turn the main power switch off before touching any part of the thruster. An incidental start while touching moving parts can cause serious injuries.
It is the owner, captains or other responsible parties full responsibility to assess the risk of any unexpected incidents on the vessel.
If the thruster stops giving thrust for some reason while manoeuvring you must have considered a plan on how to avoid damage to persons or other objects.

• Always turn the control device off when the thruster is not in use or when leaving the boat.
• When leaving the boat always turn off the main power switch for the thruster.
• Never use thrusters out of water.
• If the thruster stops giving thrust while running, there is possibly a problem in the drive system. You must immediately stop running the thruster and turn it off. Running the thruster for more than a few seconds without resistance from the propeller can cause serious damage to the thruster.
• If two panels are operated with conflicting directions at the same time the thruster will not run. If both are operated in the same direction, the thruster will run in this direction.
• If you notice any faults with the thruster switch it off to avoid further damage.
• The primary purpose of the thruster is to manoeuvre or dock the vessel. Forward or reverse speed must not exceed 4 knots when operated.

For the operation of hydraulic motor thrusters

• If the performance of the thruster is reduced check the hydraulic system or check the tunnel for marine growth.

User Operation

Please refer to the graphic for special considerations relating to your model !

The following is an operation guide to ALL Sleipner control products. Ensure to familiarise yourself with the functionality and operation of your specifi c control device.

Take time to practice operation in open water to become familiar with the thruster and to avoid damages to your boat or people.

General operation

1. Turn on the main power switch for the bow thruster. (NB: Always turn off the main power switch when not on-board.)
2. Turn on the control panel by pushing the/ both “ON” button(s) on the original Sleipner panel simultaneously.

• Turn off the control panel by pushing the “OFF” button 3. To Turn the bow/ stern in the desired direction:
  

( NB: If equipped for proportional control move the joystick equivalent to the amount of thrust you intend to receive.)

• For other controls like foot switches or toggle-switches please refer to that products user manual for detailed operational use.

Hold functionality
If equipped with ‘hold’ functionality push the button in the corresponding direction you wish the thrusters to engage a holding pattern:

Operating a combined bow and stern thruster
The combination of a bow and stern thruster offers total manoeuvrability to move the bow and the stern separately from each other or in unison. This enables the boat to move sideways in both directions or turn the boat around a 360º axis while staying stationary.

Remote controls
Ensure the remote control is held in the same direction as the boat during operation.

Drift
Depending on the sideways speed of the bow/ stern, you must disengage the control device shortly before the vessel is in the desired position.
( NB: Be aware the boat will continue to move after disengaging the thruster control.)

At any significant cruising speed (+1-2 kn) the side thruster will have little effect to steer the vessel.

Compatible Control Device Products

Please refer to the graphic for special considerations relating to your model !

PRO proportional CONTROL PANEL

*Developed for Hydraulic Thrusters
Compatible for all DC and AC thrusters

Commercial CONTROL PANEL

S-Link REMOTE CONTROL

Proportional Control Panel

Activating the bow thruster

Activating the stern thruster Activating both bow and stern thruster to push the boat sideways Activating both bow and stern thruster to rotate the boat on axis

Maintenance

Please refer to the graphic for special considerations relating to your model !

As a part of the seasonal service of your Thruster before every season, always check that:

In Water/ Out of the Water

• The area around the thruster inside the boat is clean and dry. Ensure there are no signs of water or oil leaks.
• All electrical connections are clean and fastened firmly.
• Ensure that your batteries are in good condition.

Out of Water

• Check the propeller(s) or tunnel for any damage for example impact damage.
• The propeller(s) is fastened securely to the gear leg.
• Check all components of thruster are fastened securely.
• Clean the tunnel and gear leg from marine growth.
• Paint the propeller and gear leg with anti-fouling before every season to keep it clean from sea growth. (NB: Never paint the anode, rubber seals or propeller shaft. Ensure paint does not enter the space between the propeller and the gear leg.)
• Change the anode before every season, or when half the anode has eroded. Always use a sealant or thread glue on the securing screw to ensure that it does not fall off.
• Ensure propellers are attached correctly. (NB: Counter rotating models use a left hand/ right hand propeller.)
• If an external oil tank is installed with your model, ensure the oil level remains the same.

KEY:

1. Hydraulic Motor
2. Mounting Plate
3. Motor bracket
4. Flexible coupling
5. Gear Leg
6.  Propeller
7. Anode
8. Drive pin
9. Washer
10. Lock Nut
11. Fastening Screw for anode
12. Oil drain screw
13. Shaft Key
14. Anode pins
15. Locking Washer

Basic Troubleshooting

Before seeking assistance from the website help desk from your Side-Power dealer/ distributor, please perform these tests. (NB: If you are unable to understand what to check, you must consult a Side Power distributor.)

CHECK SOLUTION

The motor runs, but there is no thrust
Check propellers are fitted, fastened correctly and not damaged on the prop shaft.| Re-fasten or replace if necessary
On counter rotating models ensure LH and RH propellers are installed correctly| Install correctly
Check the flexible coupling between the motor and drive

shaft is fitted correctly and not damaged.

| Replace if necessary
Check the gears are not damaged.| Replace if necessary
The thrusters performance is reduced
Check the propeller, gear house and tunnel are free from growth/ barnacles or debris and damage.| If there is growth in the tunnel, this will disturb/ block the water flow and significantly

reduce performance

Check oil pressure and levels.| Fill if necessary

Advanced Control Panel Troubleshooting

Control panels operating on the S-link system display all faults via the control panel interface or via other warming methods.
To review any issues of your product refer to the appropriate user manual for a complete list of fault codes and troubleshooting guides.

For additional supporting documentation, we advise you to visit our website www.sleipnergroup.com

Seasonal Checklist

Service and Support
Find your local professional dealer from our certified worldwide network for expert service and support.
visit our website www.sleipnergroup.com/support

Product Spare Parts and Additional Resources
For additional supporting documentation, we advise you to visit our website www.sleipnergroup.com and fi nd your Sleipner product.

Warranty statement

1. Sleipner Motor AS (The “Warrantor”) warrants that the equipment (parts, materials and embedded software of products) manufactured by the Warrantor is free from defects in workmanship and materials for the purpose for which the equipment is intended and under normal use and service (the “Warranty”).

2. This Warranty is in effect for two years (Leisure Use) or one year (Commercial and other Non-leisure Use) from the date of purchase by the end user (for demonstration vessels, the dealer is deemed as end user).

3. This Warranty is transferable and covers the equipment for the specified warranty period.

4. The warranty does not apply to defects or damages caused by faulty installation or hook-up, abuse or misuse of the equipment including exposure to excessive heat, salt or fresh water spray, or water immersion except for equipment specifically designed as waterproof.

5. In case the equipment seems to be defective, the warranty holder (the “Claimant”) must do the following to make a claim:

   • Contact the dealer or service centre where the equipment was purchased and make the claim. Alternatively, the Claimant can make the
     claim to a dealer or service Centre found at www.sleipnergroup.com. The Claimant must present a detailed written statement of the nature
     and circumstances of the defect, to the best of the Claimant’s knowledge, including product identifi cation and serial nbr., the date and place of purchase and the name and address of the installer. Proof of purchase date should be included with the claim, to verify that the warranty period has not expired;

   • Make the equipment available for troubleshooting and repair, with direct and workable access, including dismantling of furnishings or similar, if any, either at the premises of the Warrantor or an authorized service representative approved by the Warrantor. Equipment can only be returned to the Warrantor or an authorized service representative for repair following a pre-approval by the Warrantor’s Help Desk and if so, with the Return Authorization Number visible postage/shipping prepaid and at the expense of the Claimant.

6. Examination and handling of the warranty claim:

   • If upon the Warrantor’s or authorized service Representative’s examination, the defect is determined to result from defective material or workmanship in the warranty period, the equipment will be repaired or replaced at the Warrantor’s option without charge, and returned to the Purchaser at the Warrantor’s expense. If, on the other hand, the claim is determined to result from circumstances such as described in section 4 above or a result of wear and tear exceeding that for which the equipment is intended (e.g. commercial use of equipment intended for leisure use), the costs for the troubleshooting and repair shall be borne by the Claimant;
   • No refund of the purchase price will be granted to the Claimant, unless the Warrantor is unable to remedy the defect after having a reasonable number of opportunities to do so. In the event that attempts to remedy the defect have failed, the Claimant may claim a refund of the purchase price, provided that the Claimant submits a statement in writing from a professional boating equipment supplier that the installation instructions of the Installation and Operation Manual have been complied with and that the defect remains.

7. Warranty service shall be performed only by the Warrantor, or an authorized service representative, and any attempt to remedy the defect by anyone else shall render this warranty void.

8. No other warranty is given beyond those described above, implied or otherwise, including any implied warranty of merchantability, fitness for a particular purpose other than the purpose for which the equipment is intended, and any other obligations on the part of the Warrantor or its employees and representatives.

9. There shall be no responsibility or liability whatsoever on the part of the Warrantor or its employees and representatives based on this Warranty for injury to any person or persons, or damage to property, loss of income or profit, or any other incidental, consequential or resulting damage
   or cost claimed to have been incurred through the use or sale of the equipment, including any possible failure or malfunction of the equipment or damages arising from collision with other vessels or objects.

10. This warranty gives you specific legal rights, and you may also have other rights which vary from country to country.

Patents
At Sleipner we continually reinvest to develop and offer the latest technology in marine advancements. To see the many unique designs we have patented visit our website www.sleipnergroup.com/patents

© Sleipner Group, All rights reserved The information given in the document was right at the time it was published. However, Sleipner Group cannot accept liability for any inaccuracies or omissions it may contain. Continuous product improvement may change the product specifications without notice. Therefore, Sleipner Group cannot accept liability for any possible differences between product and document.
Register your product and learn more at www.sleipnergroup.com

SLEIPNER AS
P.O. Box 519
N-1612 Fredrikstad Norway
www.sleipnergroup.com

References

• Sleipner - Ocean born. Tech bred.
• Patents - Sleipner Group
• Support - Sleipner Group

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>