CISCO Verify the ACI Endpoint Update App User Guide
- June 5, 2024
- Cisco
Table of Contents
CISCO Verify the ACI Endpoint Update App User Guide
Verify the ACI Endpoint Update App
Verify the ACI endpoint update app is working properly by checking the network objects in the management center
Verify the ACI Endpoint Update App in the Management Center
When an APIC endpoint is pulled and pushed to the management center, it’s put
into either a dynamic object or a network object. The object is named
SitePrefix_TenantName_ApplicationProfileName_ApplicationEPGName. Following is
an example APIC tenant on which the information in this section is based.
Step 1 Log in to the management center.
Step 2 Click one of the following:
- Network object: Click Objects > Object Management > Network.
- Dynamic object: Click Objects > Object Management > External Attributes > Dynamic Objects
What to do next
For troubleshooting purposes, you can track endpoints in the APIC’s EP Tracker and Object Store Browser:
Additional notes:
- During the push process, the REST operation (POST, PUT, or DELETE) is determined based on the comparison of what data is on the APIC and what is on the management center.
- For diff calculation, each tenant updates only the data of its own tenant.
- When all endpoints are deleted from an APIC endpoint group (EPG), the corresponding object group on the management center gets deleted too. But if the object group is referenced or used in any access rule on the management center, because there is a dependency, the object group cannot get deleted. In this case, we keep the group name and put the localhost IP address, 127.0.0.1, inside the group instead.
Verify the Endpoint Update App in the ASA
When an APIC endpoint is pushed to the ASA, it’s put into a network object group named SitePrefix#TenantName#ApplicationProfileName#ApplicationEPGName.
Step 1 Start ASDM.
Step 2 Log in to the ASA.
Step 3 Click Configuration > Firewall.
Step 4 In the right pane, expand Network Objects.
Step 5 Network objects created by the Endpoint Update App are displayed
under Network Object Groups, similar to the following.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>