POWERHORSE PPW2000 2000 PSI Electric Pressure Washer User Manual

: June 5, 2024
: POWERHORSE

Table of Contents

POWERHORSE PPW2000 2000 PSI Electric Pressure Washer User Manual
USING DETERGENT
Set-up
Installing the wheels
Installing the power cord storage
Installing the front panel and gun holder
Installing the hose hook
Installing the upper handle
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

POWERHORSE PPW2000 2000 PSI Electric Pressure Washer User Manual

USING DETERGENT

Carefully pour pressure washer detergent in detergent tank.
Install blue or black soap nozzle.
Squeeze trigger and wait approx.1 minute for soap.

SPRAY TIP	SPRAY TIP APPLICATION

| Green – Narrow fan tip (25° )

■ The green pressure washer tip provides high versatility with its 25 degree angle tip. Referred to as the washing tip, because it provides adequate pressure to remove dirt from surfaces, but is designed to not damage many surfaces. This pressure washer tip is designed for “sweeping” foliage or debris given its wide angle. This tip is versatile due to its wide area of cleaning and strong pressure application.

| White – Wide fan tip (40° )

■ The white 40 degree tip, referred to as the “fan” tip creates the widest area of cleaning with relatively low pressure. This pressure washer tip is best used for light or delicate cleaning applications. It is recommended for light cleaning on wood decks and other soft or delicate surfaces.

| Black – Soap spray tip

■ The black soap spray tip, is used for soap application. Soap is applied under low pressure high volume for optimum performance. Soap cannot be applied under high pressure with this machine.

| Turbo Nozzle Tip

■ The nozzle rotates in a zero to 15 degree spray pattern in a circular motion to break down tough dirt and grime. The spray pattern can cover area of 4 to 8 inches wide, depending on a distance between the tip and the surface being cleaned.

Set-up

Connect garden hose to pressure washer water intake.
Assemble pressure washer gun to spray wand.
Connect desired pressure tip
Insert high pressure hose into trigger handle.
Connect the high pressure hose to the water outlet connector.
Turn on water at outlet.
Run water hose for 30 seconds with the motor in OFF position. This helps drain air from the hose and pump.
Connect power cord to wall outlet Extension cord not recommended
Turn on Pressure Washer IMPORTANT: Ensure water outlet is On before turning power On to avoid damage to the pump

Installing the wheels

Insert an axle (A) through a wheel (I), the axle sleeve (M), the frame of the unit and then a washer (J).
Insert a cotter pin (K) through the hole in the axle to secure. Repeat for second wheel

Installing the power cord storage

Line up the screw with the holes in power cord storage and the upper handle.
Push the screw through and tighten it.

Installing the front panel and gun holder

Line up the screw sleeves with the holes in the upper handle and push through.
Insert the screw and turn clockwise with a Phillips head screwdriver (not included) until the screw is tight.

Installing the hose hook

Line up the hose hook upper end with the holes on the back of the front panel
Insert the hose hook end into the hole and push through. Installing the hose hook
Press the hose hook lower end into the clip on the back of the front panel.