XiWXi VP12 15W Magnetic Wireless Charger User Manual
- June 5, 2024
- XiWXi
Table of Contents
15W Magnetic
Wireless Charger
User Manual
Thanks for choosing us!
This is a smartphone wireless charger that allows you enjoy the fun of
digital products easily.
Please kindly read the user manual before using it and keep it for future
reference.
Specification
Input: DC5V 3A, DC9V 2.22A,DC12V1.67A
Output: 5W/7.5W/10W/15W C
Frequency: 115~205KHZ N
Dimensions: Φ63 X 10.5mm
Charging distance: ≤10mm
Conversion: ≥72%
NW.: 57g
Connect to Power Adapter
- Plug the PD power adapter into the socket.
- Connect the type C plug to the PD power adapter.
- Turn on the socket after confirming that the above 1 and 2 are completed.
Tip: The 20W adapter and converter need to be purchased separately.
Please choose whether to use converter or not according to your adapter
interface.
Charging Mode
- When the charger is in standby mode, place your iPhone12 13 series in the charging area of the wireless charger. The charger will automatically absorb and locate and a popup will appear on your phone to indicate your phone is charging wirelessly.
- When using this wireless charger for phones without magnetic absorber, you need to make sure that the center of the mobile phone is aligned with the center of the charging area of the wireless charger and confirm that the mobile phone is in charging mode through the phone screen.
Notes
- Do not squeeze or collisions.
- Do not disassemble or throw into fire or water, to avoid causing a short circuit leakage.
- Do not use wireless charger in severely hot, humid, or corrosive environments, to avoid circuit damage and occurs leakage phenomenon.
- Do not place too close with magnetic stripe or chip card (ID card, bank cards, etc. ) to avoid magnetic failure.
- Please keep the distance at least 20cm between implantable medical devices ( pacemakers, implantable cochlear, etc. ) and the wireless charger, to avoid potential interference with the medical device.
- To take care of the children, to ensure that they won’t play the wireless charger as a toy, to avoid unnecessary accidents.
The involved images are sketch maps, the final product as per the material subjects.
Note: Only supports charging for iPhone 1213 series.
Charging speed will be very slow and will cause heat if charge for other
models of mobile phones.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.