MILLENIUM BS-2400 Steel Wind-Up Stand User Manual

June 4, 2024
Millenium

MILLENIUM BS-2400 Steel Wind-Up Stand

General information

This manual contains important instructions for the safe operation of the product. Read and follow the safety instructions and all other instructions. Keep the manual for future reference. Make sure that it is available to all those using the product. If you sell the product to another user, be sure that they also receive this manual.

Our products are subject to a process of continuous development. Thus, they are subject to change. Please refer to the latest version of the user manual which is ready for download under www.thomann.de.

Symbols and signal words

In this section you will find an overview of the meaning of symbols and signal words that are used in this manual.

Signal word Meaning
DANGER! This combination of symbol and signal word indicates an

immediate dangerous situation that will result in death or serious injury if it is not avoided.
CAUTION!| This combination of symbol and signal word indicates a pos‐ sible dangerous situation that can result in minor injury if it is not avoided.
NOTICE!| This combination of symbol and signal word indicates a pos‐ sible dangerous situation that can result in material and environmental damage if it is not avoided.
Warning signs| Type of danger
| Warning – danger zone.

Safety instructions

Intended use

This speaker stand is used for stable fixing and height-adjustable installation of loudspeaker cabinets. Use the product only as described in this user manual. Any other use or use under other operating conditions is considered to be improper and may result in personal injury or property damage. No liability will be assumed for damages resulting from improper use.
This product may be used only by persons with sufficient physical, sensorial, and intellectual abilities and having corresponding knowledge and experience. Other persons may use this product only if they are supervised or instructed by a person who is  responsible for their safety.

Safety

| DANGER!
Danger for children
Ensure that plastic bags, packaging, etc. are properly disposed of and are not in the reach of babies and young children. Choking hazard! Ensure that children do not detach any small parts (e.g. knobs or the like) from the product. They could swallow the pieces and choke! Never let children play unattended with the product.
---|---
| CAUTION!
Danger of tipping when transported under load
If the stand is moved without having removed the installed device, the stand may tip over and cause injuries and property damage. Remove the installed device before transporting the stand.
| CAUTION!
Danger of tipping on unsuitable surfaces
When the speaker stand is installed on soft or uneven ground, the stand may tip over and cause injuries and property damage. Install the stand only on even and solid surfaces.
| CAUTION!
Danger of tipping due to overload
In case of overload, the stand may tip over and cause injuries and property damage. Never exceed the maximum load capacity specified for the stand.

Features

Special features of the speaker stand:

  • Extendible up to a height of about 2.08 m
  • Centric load capacity up to 50 kg
  • Extension tube made of hardened steel
  • Legs and cross braces made of aluminium
  • M10 female thread at the 35 mm flange
  • Transport length when folded: 1.20 m

Operating

Unpack and check carefully there is no transportation damage before using the product. Keep the equipment packaging. To fully protect the product against vibration, dust and moisture during transportation or storage use the original packaging or your own packaging material suitable for transport or storage, respectively.

| CAUTION!
Danger of tipping when transported under load
If the stand is moved without having removed the installed device, the stand may tip over and cause injuries and property damage.
Remove the installed device before transporting the stand.
---|---
| CAUTION!
Danger of tipping on unsuitable surfaces
When the speaker stand is installed on soft or uneven ground, the stand may tip over and cause injuries and property damage.
Install the stand only on even and solid surfaces.
| CAUTION!
Danger of tipping due to overload
In case of overload, the stand may tip over and cause injuries and property
damage.
Never exceed the maximum load capacity specified for the stand.
| NOTICE!
Possible staining
The plasticiser contained in the rubber feet of this product may possibly react with the coating of your surface and after some time cause permanent dark stains.
In case of doubt, do not put the rubber feet directly on the surface and use a suit‐ able underlay if necessary, i.e. felt-pad floor protectors or similar.
---|---
| Comply with regulations
When installing and operating, make sure to follow the standards and regulations that apply in your country.

Setting up

  1. Unfold the feet of the stand until the cross braces are in a horizontal position.
  2. Fix this position with the safety screw on the slider to which the three feet are attached.
  3. Lift the speaker box onto the extension tube. The weight of the speaker box to be installed must not exceed the maximum centric load of 50 kg.
  4. Fold out the hand crank.
  5. To adjust the height, untighten the locking screw at the crank case.
  6. Press and hold the yellow security button at the crank case while adjusting the desired height with the hand crank.
  7. Release the yellow security button at the crank case, fix the position of the extension tube with the locking screw at the crank case and fold the hand crank back in.
Dismounting
  1. Fold out the hand crank.
  2. Untighten the locking screw at the crank case.
  3. Press and hold the yellow security button at the crank case while fully lowering the extension tube.
  4. Release the yellow security button at the crank case, fix the position of the extension tube with the locking screw at the crank case and fold the hand crank back in.
  5. Lift off the speaker box from the extension tube.
  6. Loosen the safety screw on the slider to which the three feet are attached.
  7. Fold up the feet of the stand.

Technical specifications

Height, max. 2.08 m
Total width 1.10 m
Adjustable stand height 1.24 m … 2.15 m
Stand footprint 0.62 m2
Truss length 370 mm
Stand tube diameter Æ 36 mm
Holder type M10 female thread at the top end / 35 mm flange
Max. load capacity (for centric load) 50 kg
Transport dimensions (W × H × D) 140 mm × 1200 mm × 190 mm
Weight 8.2 kg
Colour Black

Further information

Speaker flange 35 mm / M10 female thread
Set of 2 stands No
Material Steel
Crank stand Yes
Ringlock No
Pneumatics No
Foot type Tripod

EU Declaration of Conformity

Name and address of manufacturer / EU-AR| Thomann GmbH
Hans-Thomann-Straße 1
96138 Burgebrach Germany
---|---
THIS DECLARATION OF CONFORMITY IS ISSUED UNDER THE SOLE RESPONSIBILITY OF:
Name and address of| Thomann GmbH
manufacturer| Hans-Thomann-Straße 1
96138 Burgebrach
Germany
Product identification| 168996 Millenium BLS-2400 Speaker Stand
THE PRODUCTS MENTIONED IN THIS DECLARATION ARE IN CONFORMITY WITH:
EU Community Legislation| Machinery Directive 2006/42/EC
Harmonised standards| Safety of machinery

EN 1005-3:2002 + A1:2008 EN 13157:2004 + A1:2009 EN ISO 12100:2010

SIGNED FOR AND ON BEHALF OF:
Place and date of issue| Burgebrach, 29 November 2021

Protecting the environment

Disposal of the packaging mate‐ rial

| For the transport and protective packaging, environmentally friendly materials have been chosen that can be supplied to normal recycling.
Ensure that plastic bags, packaging, etc. are properly disposed of.
Do not just dispose of these materials with your normal household waste, but make sure that they are collected for recycling. Please follow the notes and markings on the packaging.
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals