CBG 1240278 WireFree RTS Motor User Guide

June 3, 2024
CBG

CBG.jpg

CBG 1240278 WireFree RTS Motor User Guide

Sonesse® ULTRA 30 WireFree Li-ion | Sonesse® 28 WireFree Li-ion | Sonesse® 40 WireFree Li-ion Sonesse® 28 WireFree External Battery | Cord Lift WireFree TL25 Motor

IMPORTANT: Upper and lower limits are set at the factory. In the event limit setting is required, follow steps to RESET MOTOR TO FACTORY MODE and proceed with INITIAL PROGRAMMING AND LIMIT SETTING.

TO FINISH PROGRAMMING:

FIG 1 TO FINISH PROGRAMMING.JPG

INITIAL PROGRAMMING AND LIMIT SETTING

NOTE: Motor will exit programming mode after 2 minutes of inactivity. Prior to confirming limits, the shade only operates when the UP or DOWN buttons are continuously pressed. Releasing the buttons stops the shade.

FIG 3 INITIAL PROGRAMMING AND LIMIT SETTING.JPG

ADJUSTING THE LIMITS IN USER MODE

FIG 4 ADJUSTING THE LIMITS IN USER MODE.JPG

ADD OR DELETE A TRANSMITTER

FIG 5 ADD OR DELETE A TRANSMITTER.JPG

ENABLING SLEEP MODE

The shade must be programmed.

This feature temporarily prevents the motor from responding to any previously programmed remote commands.

FIG 6 ENABLING SLEEP MODE.JPG

NOTE: If step 3 is not performed, Sleep Mode will automatically disable after approximately 10 minutes.

RESETTING THE MOTOR TO FACTORY MODE

PRESS & HOLD the PROGRAMMING BUTTON on the motor (shown below) for approximately 12 seconds during which the shade will jog 3 separate times.

FIG 7 RESETTING THE MOTOR TO FACTORY MODE.JPG

All programmed remotes and limit settings will be erased. Motor is now reset to factory mode. Motor limits will need to be re-established.

SETTING FAVORITE “MY” POSITION

FIG 8 SETTING FAVORITE MY POSITION.JPG

  1. To set a NEW “my” position, repeat steps 1 and 2.

TO DELETE: First send the shade to the current “my” position, then PRESS & HOLD the
MY/STOP button for 5 seconds. The shade will jog to confirm deletion.

FIG 9 USING THE FAVORITE MY POSITION.JPG

ADJUSTING THE SPEED

LED blinks alternately in green and yellow during the adjustment.

  1. Move the shade away from the end limits. PRESS & HOLD the UP, MY/STOP and DOWN buttons simultaneously, until the shade jogs. The shade will move up and down automatically in 10 second cycles.

FIG 10 ADJUSTING THE SPEED.JPG

Read More About This Manual & Download PDF:

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals