LISKA SV-33FC Smart Watch Instructions

LISKA SV-33FC Smart Watch Instructions

Getting started

Caution: When the first time you use the fitness tracker, please make sure to full charging before using. Please read this user guide carefully before using the product. lt contains important information for your safety as well as use and maintenance advice.

Safety precautions

• The product contains electrical components that could cause injury if not handled properly.
• Do not open the enclosure or disassemble the product.
• Do not expose the product to extremely high or low temperatures.
• Do not use the product in a sauna or steam room.
• Do not leave the product in direct sunlight for an extended period of time.
• Do not dispose the product in a fire, the built-in battery can explode.
• The product features a built-in battery, which is not user replaceable.
• Do not check call notifications or other data on the product’s screen while driving or in other situations where distractions could be hazardous.
• The distance travelled may be inaccurate. lt is for reference only and should not be used as any navigational reference.
• The product should usually resta finger’s width below the wrist bone, as you would normally wear a watch.
• This product has been classified as IP67.

Caution: The device may cause skin irritation. Prolonged contact may contribute to skin irritation or allergies in some users. lf you notice any signs of skin redness, swelling, itchiness or other skin irritation, please discontinue using the product. Continued use, even after symptoms subside, may result in renewed or increased irritation. If symptoms persíst, consult your doctor.

Blood Oxygen Notice

• WARNING! Only a medical practitioner is qualified to interpret your blood oxygen measurements.
  The use of this smart bracelet should not replace regular medical examinations.

• Blood Oxygen can be subjected to wide fluctuations in a short period of time as its level depends on many factors.

• Different medicines, alcohol and smoking can exert a large influence on the level of Blood Oxygen. Do not smoke, drink caffeinated beverages or exercise within 30 minutes before measuring your blood oxygen.

Intended Use

This smart bracelet is intended for monitoring fitness-related metrics such as heart-rate, blood pressure, distance walked or run, calorie consumption and quality of sleep. Data measured should not be used far any medical, ambulatory or dietary reference.

Product Overview

Specifications

• CPU:HS6621.
• 0.96 inch TFT display.
• Lithium battery 200mAh.
• Operating time: up to 7-10 days.
• Compatible with IOS 8.0 and Android 4.4 or higher .
• Charging cable included.
• Protection class: IP67.

Fitness Tracker Key Features

Operation

Synchronize the fitness tracker via app with your mobile device

1. Download “FitCloudPro “ from App Store (IOS) or Google play
   

2. Activate the Bluetooth function on your mobile device.

3. Open the “FitCloudPro “ app on your mobile device (keep the bracelet near your mobile device during pairing).

4. Pair the bracelet with your mobile device by following the steps below:
   

5. .After synchronizing you can personalize your app by entering your personal details and set your daily workout goals.

Functions

Sleep mode
This function detects automatically your sleep status and monitors the sleeping progress based on your movements during the night.

On the bracelet
Press the screen repeatedly, until the following screen appears.

Exercise mode

Note: The running distance is calculated by your stride length based on personal configuration and number of steps.

Note : Only start on bracelet the app will recording the data. Bracelet data will start from zero every day at 00:00h. Once you connect the bracelet via the app with your mobile device, data will be stored for further monitoring.

The app also provides a GPS and running function. The GPS function visualizes the covered track, the distance covered, time, average speed and calories consumed.

Measurements
The device allows you to measure heartbeat, and the percentage of oxygen in the blood. You can measure only from bracelet .The data will be automatically synchronized to the APP on the phone.
Press the central button repeatedly, until the desired measurement screen appears. At the rear of the bracelet a green light beam appears and you can start measuring.

Chronometer

• Press the screen repeatedly, until the following screen appears.
• Press and hold the button until the stopwatch appears.
• Press again to start/stop the time.
• Press and hold the central button to turn off the stopwatch.

Remote Shutter
This device can be controlled remotely. Select this item in the app to turn on the camera and take photos with the band shake.

Alarms
The device allows you to set different alarm types, such as message notification or call reminder.
Follow the steps below to activate the alarms:

Please follow the steps below to activate the App reminder:

Note: For future updates, the app functions may be affected.

Bright screen setting

Power off

1. Press and hold the screen , until the following screen appears.
2. Press and hold the button, until the bracelet turns off.

Charging

Use the supplied cable to charge the device. Using Magnetic charger charging, then connect the USB plug to a suitable power supply (PC or charger).

Cleaning and storage

• Turn the product off before cleaning.
• Clean and dry the product regularly, particularly in areas in contact with the skin. Do not use chemical or abrasive cleaners.
• Clean the device regularly as accumulated dust and lint could affect charging process.
• When not in use, store the product in its original packaging, out of reach of children and pets.

Disposal

Used electrical and electronic products must not be discarded with household waste. The presence of this symbol on the product serves as a reminder of this. Some of the materiaIs of which this product is comprised can be recycled if they are taken to an appropriate recycling center. By reusing the components and raw materials of used products, you contribute significantly to protecting the environment. For further information on collection sites for used equipment, you can enquire at your town council or the waste treatment department.
Do not dispose of batteries with the household waste. Return used batteries to a battery recycling center.

Warranty

We do not advise immersion of watches and we do not accept their return as a guarantee, since we consider them only IMPERMEABLE.
We also do not recommend having a shower with it, as the hot water vapor can affect both the battery and the clock module. Also avoid sudden changes in temperature.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>