ZKTeco SpeedFace-V3L Series Device Installation Guide
- June 4, 2024
- ZKTECO
Table of Contents
ZKTeco SpeedFace-V3L Series Device
How to Install the Device?
Installation Environment
Please refer to the following recommendations for installation.
Device Installation
- Attach the mounting template sticker to the wall, and drill holes according to the mounting paper
- Fix the backplate on the wall using wall mounting screws.
- Attach the device to the backplate.
- Fasten the device to the backplate with a security screw
Wiring Diagram
Power Connection
Recommended AC Adapter：
- 12V ± 10%, at least 1500mA.
- To share the power with other devices, use an AC Adapter with higher current ratings.
Ethernet Connection
Connect the device and computer software over an Ethernet cable. As shown in
the example below:
Click on [COMM.] > [Ethernet] > [IP Address] , input the IP address and
click on [OK].
Note: In LAN, the IP addresses of the server (PC) and the device must be in
the same network segment when connecting to the ZKBio Access software.
Wiegand Reader Connection
Note: 485A and 485B can be connected to the Barrier gate or the 485 Reader, separately, but cannot be connected to the gate and reader at the same time.
RS485 Connection
Door Sensor, Exit Button, Alarm & Auxiliary Connection 
Lock Relay Connection
The system supports Normally Opened Lock and Normally Closed Lock. The NO
LOCK (normally unlocked when power-on) is connected with ‘NO’ and ‘COM ‘
terminals, and the NC LOCK (normally locked when power-on) is connected
with ‘NC’ and ‘COM’ terminals. Take NC Lock as an example
below:
Download Center
Scan the QR Code to download the User Manual, Installation Guide and Quick Start Guide.
ZKTeco Industrial Park, No. 32, Industrial Road, Tangxia Town, Dongguan,
China.
Phone : +86 769 – 82109991
Fax : +86 755 – 89602394
www.zkteco.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>