SANUS SA-IWCM2 In Wall Cable Management Kit Instruction Manual
- June 4, 2024
- SANUS
Table of Contents
SANUS SA-IWCM2 In Wall Cable Management Kit Instruction Manual
IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ ENTIRE MANUAL PRIOR TO USE SAVE THESE INSTRUCTIONS
CAUTION: Avoid potential personal injuries and property damage!
- FOR LOW VOLTAGE CABLES ONLY.
- RISK OF FIRE – DO NOT install power supply cord within the wall cavity.
- Do not use this product for any purpose not explicitly specified by manufacturer.
- Manufacturer is not responsible for damage or injury caused by incorrect assembly or use.
- If you do not understand these instructions or have doubts about the safety of the installation, assembly or use of this product, contact customer service.
We’ll Make It Stress-Free
If you have any questions, just give us a call.
Legrand AV Inc. and its affiliated corporations and subsidiaries (collectively, “Legrand”), intend to make this manual accurate and complete. However, Legrand makes no claim that the information contained herein covers all details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Legrand makes no representation of warranty, expressed or implied, regarding the information contained herein. Legrand assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
©2021 Legrand AV Inc. All rights reserved. SANUS is a brand of Legrand. SANUS
and the SANUS logo are registered trademarks.
All other brand names or marks are used for identification purposes and are
trademarks of their respective owners.
Legrand AV Inc.
6436 City West Parkway
Eden Prairie, MN 55344 USA
Tools Required
Installation Instructions
-
Find you desired locations (between studs).
-
Trace the template at your locations.
-
Cut out the holes in the drywall.
-
Run your low voltage cables.
-
Snap the lock tabs in place.
-
Hand tread the screws into the lock tabs.
-
Insert into the wall and secure the lock tabs by turning the scews.
-
Install the cover plate.
USE THIS FOR STEP 2
Trace around edge of this template to cut drywall holes for brush strap wall
plates.
Model SA-IWCM2-W1 Wall Plate Template 6700-301790<00>
©2021 Legrand AV Inc. All Rights Reserved. SANUS is a brand of Legrand. SANUS and the SAN US logo are registered trademarks of Legrand.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>