progetto KUBE Wall Hung Basins Instruction Manual
- June 1, 2024
- progetto
Table of Contents
progetto KUBE Wall Hung Basins
Product Specifications
- Product Name: KUBE Wall Hung Basins
- Recommended Wall Type: Cement-based non-compressible wall lining
- Manufacturer: Plumbline
- Contact: T 04 568 9898 | E sales@plumbline.co.nz | Website: www.plumbline.co.nz
Product Usage Instructions
Installation
- Ensure there is sufficient timber framing in the wall to securely fasten the basin to.
- Drill holes in the required positions into the timber framing using a 7mm drill bit.
- Screw a fixing bolt into each hole using an 8mm spanner to tighten. Ensure it contacts the wall.
- Place the basin against the wall, aligning the fixing bolts through the holes in the rear of the basin. Push a plastic washer onto each bolt.
- Check that the basin is level before securing it in place.
- Secure the basin by screwing the metal nut onto each fixing bolt.
- Apply a small bead of silicone around the back edge of the basin and install the tapware, waste, and bottle trap.
Frequently Asked Questions (FAQ)
-
Q: Can I install the wall hung basin on any type of wall?
A: It is recommended to install wall hung basins against a cement-based non- compressible wall lining to prevent damage due to weight. -
Q: How do I ensure the basin is securely fastened to the wall?
A: Make sure to drill holes into sufficient timber framing and use the provided fixing bolts, washers, and nuts as instructed in the installation manual. -
Q: What should I do if the basin is not sitting level?
A: Before securing the basin, ensure it is level. You may need to adjust the positioning or use shims to achieve a level installation. -
Q: Can I use any type of sealant for sealing the basin?
A: It is recommended to use silicone sealant around the back edge of the basin for proper sealing.
INSTALLATION INSTRUCTIONS
KUBE WALL HUNG BASINS
IMPORTANT!
- Please read these instructions prior to installation
- Because the weight of a wall hung basin and the weight that comes from people leaning on the basin can crush the wall lining if a plaster board is used, we recommend wall hung basins are installed against a cement based non-compressible wall lining.
Installation Instructions
Important! Before installing ensure there is sufficient timber framing in
the wall to securely fasten your basin to.
Bolt Set Supplied
Installation Instructions
- Drill holes in the required positions into the timber framing using a 7mm drill bit.
- Screw a fixing bolt into each hole using an 8mm spanner to tighten. Tighten until the spanner contacts the wall.
- Place the basin in position against the wall, locating the fixing bolts through the holes in the rear of the basin. Push a plastic washer onto each fixing bolt.
- Before fixing the basin in place, ensure that the basin is sitting level.
- Screw the metal nut onto each fixing bolt to secure the basin in place.
- Apply a small bead of silicone around the back edge of the basin. Finally fit the basin with the chosen tapware, waste and bottle trap.
Distributed by:
- T 04 568 9898
- E sales@plumbline.co.nz
- www.plumbline.co.nz
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>