CURT 51438 Brake Control Harness Instruction Manual
- June 4, 2024
- Curt
Table of Contents
**CURT 51438 Brake Control Harness Instruction Manual
**
NOTICE
All steps must be followed to ensure the CURT brake control harness will
function properly. Once installed, test for proper function by following the
brake control unit instruction manual.
LOCATION GUIDE
Representative vehicle shown below
BH8 – Under dash, to right of emergency brake pedal
INSTALLATION / SAFETY INSTRUCTIONS
Step 1
Locate the 4-pin, vehicle brake control harness connector under the dash, to
the right of the emergency brake pedal. It will be taped to another harness.
The connector will be similar to that on the CURT brake control harness (A).
Step 2
Insert the connector on the CURT brake control harness into the vehicle
connector. Make sure the connector is fully inserted with locking tabs in
place (B).
Step 3
Insert the brake control harness’s black connector into the brake control’s
quick plug connector. Secure the brake control harness with the provided cable
ties, avoiding any pinch points.
Step 4
Complete the installation using the brake control instructions. Mount the unit
as directed and perform test procedures as instructed in the brake control
user manual.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>