FACTORY 2017-2023 Ford Super Duty Light Mount Instruction Manual
- June 4, 2024
- Factory
Table of Contents
FACTORY 2017-2023 Ford Super Duty Light Mount
Product Information
Specifications:
- Compatible Vehicles: 2023+ FORD F-250 thru F-550
- Tools Required: 18MM Socket/Wrench, 2 Hole Saw Bit/Drill
- Additional Recommendations: Safety glasses, Blue Masking Tape, Locking hardware for lights and light bar
Product Usage Instructions
- Set-Up: Ensure the vehicle is on a level surface, in PARK, with tires chocked and emergency brake ON. Wear safety glasses.
- Removing the Plastic Trim Cover: Gently remove the plastic trim covers around the front tow hooks to access the bumper bolts.
- Where to Drill: Use the provided templates to mark the center point for drilling. Double-check alignment before drilling.
- Drilling the Hole: Prop up and level out the part using pieces of wood. Align the hole saw bit properly and drill. Clean up any rough edges with sandpaper.
- Removing the Lower Bumper Bolts: Using an 18mm socket, remove the bolts on each side.
- Re-Install Plastic Pieces: Ensure metal clips are attached, align and snap plastic pieces back into place. Use Blue Masking Tape to prevent scratches.
- Installing the Light Bar: Lift the light bar into place, line it up with factory bumper bolt holes, hand thread the bolts, connect wiring to lights, and tighten bolts. Use locking hardware for added security.
Tools REQUIRED
- 18MM Socket
- Wrench & 2” Hole Saw Bit
- Drill
Tech Tip: This is the best time to install the lights (of your choice) onto the light bar to make sure everything fits correctly.
FAQ
Q: Can I install any type of lights on the light bar?
A: Yes, you can install lights of your choice onto the light bar to ensure
proper fitment.
Q: Do I need to use locking hardware for the lights and light bar?
A: Locking hardware is highly recommended for added security and is available
through us.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>