Qifeng Toys Factory SU-35 Fighter 4 Channel 2.4GHz Bomber RC Airplanes Instructions
- June 3, 2024
- Qifeng Toys Factory
Table of Contents
Qifeng Toys Factory SU-35 Fighter 4 Channel 2.4GHz Bomber RC Airplanes
Thank you for buying QIFENG products. QF009 is the latest technology in RC
models. Please read this manual carefully before assembling and flying the new
QF009
airplane. We recommend that you keep this manual for future reference
regarding tuning and maintenance.
INTRODUCTION
Thank you for choosing Qi Feng product! QF009 is a world’s first in a smaller space, and outdoor sport flying remote control fixed-wing aircraft, in order to make it easier and easier Use QF009, please read the complete instructions after operating this model airplane, For your convenience, please read this manual before use and keep the instructions.
WARNING : Mishandling due to failure to follow these instructions may
result in damage or injury.
CAUTION : Mishandling due to failure to follow these instructions may
result in damage.
FORBIDDEN : Do not attempt under any circumstances.
IMPORTANT NOTES:
- QF009 is not toys product operational process is dangerous, Please follow the instructions of the instructions and any modifications mat result in accidental injury. The use of this airplane beyond its intended purposes and disassembly may cause unforeseen danger, and should be avoided.
- This product is only suitable for use over 14 years old. The manufacturer will not responsible for any accidents caused by improper operations.
- We recommend that you seek assistance or an experienced pilot before attempting to fly our products for the first time. A local expert is the best way to properly assemble, setup, and fly your model for the first time. The requires a certain degree of skill to operate and is an item subject to normal wear and tear. Please contact the dealer for after-sales problems.
SAFETY NOTES
WARNING : Fly only in safe areas, away from other people. Do not operate
R/C aircraft within the vicinity of crowds or people. R/C aircraft are prone
to accidents, and failures and are responsible for their actions and damage or
injury that occurred during pilot error, and radio interference. Pilots are
responsible for their actions and damage or injury incurred during the
operation or as of a result of R/C aircraft modeis.
This product is suitable for indoor and outdoor(the wind grade should be no more than 4), please choose a place without obstacles, and keep your distance from crowds and pets, don’t play it under safety, for instance, heat source, wire or electronic power source, in order not to be damaged by collision landing, ending element and lead to a fire, electric shock and cause losses of lives and property.
PREVENT MOISTURE
R/C modeis are composed of many precision electrical components. It is critical to keep the model and associated equipment away form moisture and other contaminants. The introduction or exposure to water or moisture in any form can cause the model to malfunction resulting in malfunction, or a crash. Do not operate or expose to rain or moisture.
BATTERY PRECAUTION:
In order to avoid potential fire hazards caused by batteries, do not short
circuit the polarity of batteries or pierce them. Batteries must be charged
away from children and under
supervision.
PROPER OPERATION:
To avoid potential fire hazard from batteries, please do not short, reverse polarit, or puncture batteries. Battery chary charging must be done under supervision at all times, and at location out of reach by children.
SAFETY NOTE FOR ION BATTERY
Make sure the batteries are installed based on polarity lndicated in the case and do not mix batteries of different chemistry/specs. Please take out the batteries if you are not going to use for a long time to avoid potential leakage which may damage the transmitter. Please dispose of depleted batteries according to local laws and ordinances. Do not dispose of improperly.
SAFETY NOTE ON Li- POLYMER BATTERIES
Li-Polymer batteries poses higher operational risks compared to other battery chemistry, thus it is imperative to follow its usage instructions. Manufacturers and dealers assume no liability for accidental damages caused by improper usage.
- Do not use charger other than the factory-supplied unit to avoid potential fire and explosion. Do not crush, disassemble, burn, and reverse polarity. Avoid metallic materials to come into contact with battery’s polarity and cause it short and never puncture batteries to avoid fire hazards.
- Battery charging must be done under supervision at all times, and at locations out of reach by children.
- Please stop the use or charge of the battery should there be an unusual increase in battery temperatue after use. Continue use of this battery may cause it to expand, deform, explode, or even result in file hazards.
- Please dispose depleted batteries according to local laws and ordinances. Do not dispose improperly.
KEEP AWAY FROM HEAT
STANDARD EQUIPMENT
REPLACEMENT PROPELLER
Press the propeller in the direction of the arrow to exit the paddle, and then replace the new propeller.
Installation steps
Do not disassemble
When the remote control is in the state of the small rudder, the indicator light continues to flash quickly, indicating that the remote control battery is Out of power. Please replace the battery as soon as possible.
TRANSMITTER BATTERY INSTALLATION
- Slide the battery lid to open by following the arrow
- Please use 4AA-sized batteries, Installed based on the polarity indicated case. Do not mix batteries of different chemistry/specs.
BATTERY CHARGING
BINDING OF RADIO TRANSMITTER AND RECEIVER
Step 1: Plug in the batteries and turn on the power switch. The aircraft indicator flashes.
Step 2: Turn on the remote control, when the remote control and receiver light Flash, a few seconds after the remote control and receiver lights become often lit, the code is completed.
FLIGHT AND LANDING
TAKE OFF: Put the plane on a flat surface and accelerate in the wind, when the plane reaches a certain speed. gently pull the direction joystick and the plane will take off.
Hang throwing off: Puse the throttle to about 60%, Throw in the horizontal direction against the wind and pull the direction joystick at the same time.
- Error to throw up
- Correct to throw horizontally
- Error to throw down.
Landing : Please landing when the aircraft is underpowered. First reduce the flying flying height, then land in the wind, pull the throttle joystick until airplane landing.(Push the direction joystick proerly during the Ian sing}
Ending flight: Please remove the battery in time when the Hight
finish.
Warning : If left connected in the airplane for long duration, the battery may be damaged due to over-discharge, or even become fire hazards.
Power ON/OFF: If transmitter is not to be used for a long duration, please remove the battery for star.
WARNING : If you do not use the remote control for a long time, please remove the battery.
FLIGHT ADJUSTMENT AND SETTING
Please read the Instructions and repeat the exercises before the actual operation.
- Please operate in an open space, and place the aircraft directly in front of the operator.
- Practice operating the throttle stick(as in below illustration) and repeat practicing throttle high/low, Aileron left/right, “Rudder left/right, and “Elevator up/down.
- The simulation flight practice is very important, please keep practicing until the flingers move naturally when you hear operation orders being called out.
FLIGHT ADJUSTMENT AND NOTICE FOR BEGINNERS
Check if the transmitter and receivers are fully charged. Please operate in an open space.
STEP 1: THROTTLE CONTROL
After the plane takes off, please control the throttle so that the plane can
fly at a constant speed. Do not suddenly accelerate.
Note : make sure you push the throttle as far as you can in 3D!
Use the rudder to control the grand taxiing direction and air flight direction.
When the rudder Is pressed, the Indicator on the remote will flash and the aircraft can do some tumbling. Press the big rudder switch first, then pull the upgrade rudder rod to pull the ribs. The plane will have smaller turning rad-ins during the rudder, and the aircraft will be more flexible to tum.
One-button reverse flight mode: press on the remote control the one- button reverse flight mode
Note : when flying, please select the small rudder mode on the upper
right corner, and then select 3D mode for the button in the upper left corner
(large rudder mode can be used after skilled flight control)
Note : press the button in time when you can’t control the aircraft in a
dangerous situation upper left button, switch to 6D mode to remove danger.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>