BADI TOYS FACTORY BD002 Wireless Remote Control Toy Car Instructions
- June 1, 2024
- BADI TOYS FACTORY
Table of Contents
BADI TOYS FACTORY BD002 Wireless Remote Control Toy Car
Product Information
Specifications
- Product: Remote control toy car BD002
- FCC Compliance: Part 15 of the FCC Rules
- RF Exposure: Meets general RF exposure requirements
Product Usage Instructions
FCC Compliance
The remote control toy car BD002 complies with part 15 of the FCC Rules.
Ensure that the operation of this device does not cause harmful interference
and that it accepts any interference received.
Modifications
Any changes or modifications not expressly approved by the responsible
party may void the user’s authority to operate the equipment. Follow these
guidelines:
- Reorient or relocate the receiving antenna.
- Increase separation between equipment and receiver.
- Connect the equipment to a different circuit than the receiver.
- Consult a dealer or experienced radio/TV technician for assistance.
RF Exposure
The device has been evaluated to meet general RF exposure requirements,
allowing it to be used in portable exposure conditions without restrictions.
Frequently Asked Questions (FAQ)
-
Q: Is the remote control toy car BD002 suitable for outdoor use?
A: Yes, the toy car is suitable for both indoor and outdoor use, providing versatility in play environments. -
Q: How do I change the batteries in the remote control?
A: To change the batteries in the remote control, locate the battery compartment, usually at the back of the remote. Open the compartment, remove the old batteries, and replace them with new ones following the polarity markings.
INSTRUCTIONS
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
- Use 2″AA” size batteries (Batteries included).
- Do not use rechargeable batteries.
- Non-rechargeable batteries are not to be recharged.
- Only batteries of the same or equivalent type as recommended are to be used.
- Batteries are to be inserted with the correct polarity.
- Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
- Packing has to be kept since it contains important information
PLEASE RETAIN PACKAGING FOR FUTURE REFERENCE. SPECIFICATIONS, COLORS AND CONTENTS MAY VARY FROM ILLUSTRATIONS
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning for Portable device
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.