Xiongqi Toys Factory 989-313 2.4GHz Amphibious Stunt RC Car Instruction Manual

Xiongqi Toys Factory 989-313 2.4GHz Amphibious Stunt RC Car

Warning:

1. Please read this instruction manual carefully before installing operating this car.
2. Children aged under 3 need adults’ supervision while playing.

Package Contents

• Car x 1
  

• Remote Controller (without battery) x 1
  

• Screwdriver x 1
  

• Instruction x 1
  

• Rechargeable Battery (Use for the car) x 2
  

• USB Charging Cable x 1
  

Installation

1. Fully recharge the battery with the USB charging cable provided at first.(P1)
2. lnstall 2*1.SV “AA” batteries in remote controller(not waterproof).(P2)
3. lnsert the rechargeable battery into the car case.(P3)
4. Turn on the remote controller, the indicator light will flash (P4)
5. Switch on the car, the LED on the body will keep flashing. Then you can press the button to play with the car.(PS)
   
   

Notes :

1. After playing with the car in the water, please switch off the car and drain the water from battery case to make sure every part inside is dry.
2. Please fully charge the battery before playing for the first time.
3. When the battery is charging, the indicator USB will light up red; when it is fully charged, the indicator light will turn off.(Around 2.5H)
4. Please don’t overcharge it, or it will shorten the battery life.

Operation Direction

Troubleshooting

when the light is flashing.
How can I know if the signal pairing is successful or not?| Indicator light on the remote controller will flash when it is switched on, and then it will be turned off once paired successfully after your car is turned on.
The car runs slowly|

1. Replace or fully recharge the battery
2. Check if the car is geared properly or the gears are dirty

The car doesn’t work|

1. Make sure all switches are turned on
2. Check if all batteries are fully powered.(including the batteries of the remote controller and the car)
3. Check if there are damages of the car or remote controller

The car only turns and cannotmove forward or backward|

1. Recharge the battery of the car or replace the batteries of the remote controller.
2. Push the upward or downward button to check if the indicator light flashes
3. Re-pair the signal by re-switching them on. 4.Check if the motor is damaged.

The car only move forward or backward cannot turn.|

1. Check if the car or remote controller is damaged.

Battery information

• INPUT: 5V 2A

• OUTPUT: 7.4V 0.5A

• Battery: 1 x 7.4V 500mAh lithium ion

• Rechargeable Battery Pack

• Requires: 1 x 7.4 V 500mAh lithium ion

• Rechargeable Battery Pack
  

• Battery requirement for controller:
  

• Batteries: 2x 1.5V AA
  

• Requires 2×1 .5V AA size batteries (not included)

The Waste Electrical and Electronic Equipment Directive (WEEE Directive) is the European community directive on waste electrical and electronic equipment, which became European law in February 2003. The main purpose of this directive is to prevent electronic waste. Recycling and other forms of waste recovery should be encouraged to reduce waste. The symbol (trash can) on the product and on the packing means that used electrical and electronic products should not be disposed of with general household waste. It is your responsibility to dispose of all your electronic or electrical waste at
designated collection points. Disposing of this product correctly will help to save valuable resources and it is a significant contribution to protect our environment as well as human health. For more information about the correct disposal of electrical and electronic equipment, recycling and collection points please contact your local authorities, waste management companies, your retailer or the manufacturer of this device.

Batteries are marked with the symbol of a crossed out bin. This symbol indicates that empty batteries or accumulators which can no longer be charged should not be disposed of with household waste. Waste batteries may contain harmful substances that can cause damage to health and to the environment. Please use the return and collection systems available in your country for the disposal of the waste batteries.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be u seed in portable exposure condition without restriction

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>