Image Engineering TE292 Spectral Sensitivity Measurements with iQ-LED User Manual
- June 3, 2024
- Image Engineering
Table of Contents
Image Engineering TE292 Spectral Sensitivity Measurements with iQ-LED
INTRODUCTION
Important information: Read the manual carefully before using the device. Inappropriate utilization may cause damage to the device. Keep these instructions in a safe place and pass them to any future user. The TE292 and TE292 VIS-IR filter plates are intended for use with the Image Engineering LE7 or LE7 VIS-IR illumination device, iQ-LED software, and the camSPECS software. Refer to the user manuals for each of these products for detailed operating instructions. The TE292 and TE292 VIS-IR bundle includes the filter plate, calibration plate, and calibration plate thumb nut.
OPERATING INSTRUCTIONS
- Remove the packaging material and insert the TE292 or TE292 VIS-IR into the test chart holder of the LE7 or LE7 VIS-IR as pictured:
- Power up the LE7 or LE7 VIS-IR and connect the USB cable between the device and the host computer.
- Using the IQ-LED software, create an E illuminant at near full power and save to the device as described in the iQ-LED user manual.
- Disconnect the device’s USB cable.
- Connect the EX2 spectrometer calibrator USB cable to the host computer.
- From the control panel on the device, select the E illuminant saved to the device earlier.
- Launch the cam specs software and perform the calibration as described in the cam specs user manual.
- To perform camera spectral sensitivity measurements, proceed as described. The camera exposure will depart from the typical settings suggested and should be optimized as described in the cam specs user manual.
MAINTENANCE
TE292 and TE292 VIS-IR do not need any special maintenance, however:
- Do not touch or pollute the surfaces of the filters.
- Remove dust on the filters with pressurized-air spray.
- Remove undesired fingerprints or oils on the filters carefully with a soft and dry tissue
Image Engineering GmbH & Co. KG · Im Gleisdreieck 5 · 50169 Kerpen-Horrem
· Germany
T +49 2234 2273 99 99 1-0 · F +49 2234 2273 99 99 1-10 · www.image-
engineering.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>