Hunter Lenlock Two Light Vanity Instruction Manual

: June 3, 2024
: Hunter

Table of Contents

PREPARING FOR INSTALLATION
CONNECTING THE WIRES
FINISHING THE INSTALLATION
CLEANING TIPS
Tools Needed
INSTALLATION INSTRUCTIONS
Hardware Service
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Hunter Lenlock Two Light Vanity Instruction Manual

PREPARING FOR INSTALLATION

Carefully remove all contents from the carton. Shut off the power at the circuit breaker and completely remove the old fixture from the wall, including the old mounting bracket. Remove the new mounting bracket assembly from the bag. Put the drywall anchor (F) inside the hole in the wall. Pull the house wires through the center of mounting plate (A). Secure mounting plate (A) to the junction box by tightening the screws (B) then insert the drywall screw (G) through the mounting plate (A) into the drywall anchor (F). For a vertical installation make sure the mounting plate (A) has the folded sides with drilled holes at the top and bottom of the junction box.

CONNECTING THE WIRES

Have a helper support the fixture’s weight while completing the wiring. Attach the fixture’s wires to the power supply wires from the junction box. Connect black to black (live); white to white (neutral); grounding to grounding (green or copper). Twist the ends of the wire pairs together. Then, twist on a wire connector. Make sure all twists are in the same direction. Loop fixture’s ground wire around grounding screw (C) and tighten. If there is no ground wire (green or copper) from the junction box, contact a qualified electrician.

FINISHING THE INSTALLATION

Place the fixture (E) over the mounting plate (A) making sure to align the holes of the fixture with the holes of the mounting plate. Secure the fixture with screws (D). Install the bulbs according to the fixture specifications (not included). Do not exceed the recommended wattage. Lift the glass (H) and align the notches in the glass with the tabs in the lamp cup (E). Attach the glass by lifting and turning clockwise one third of a full turn of the glass until it stops. Turn on the power and test the fixture. Your installation is now complete.

CLEANING TIPS

Treat the fixture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture.

Tools Needed

Ladder
Screwdriver
Pliers
Wire Strippers
Drill

INSTALLATION INSTRUCTIONS

**WARNING

**

To avoid possible electrical shock, before installing your light fixture, disconnect the power by turning off the circuit breakers to the outlet box associated with the wall switch location.
The lighting fixture must be grounded. If the ground wire for the installation site is not present, immediately STOP installation and consult a qualified electrician.
All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring or in doubt, consult a qualified electrician.

READ AND SAVE THESE INSTRUCTIONS
These instructions are provided for your safety. It is very important that they are read carefully and completely before beginning installation of the lighting fixture.