anko P_43199365 Low Voltage 50cm Tinsel Wreath User Manual
- June 3, 2024
- Anko
Table of Contents
P_43199365 Low Voltage 50cm Tinsel Wreath
User Manual
LOW VOLTAGE TINSEL WREATH WITH LIGHTS
These instructions are for your safety. Please read through them thoroughly before use and retain them for future reference.
Before You Start
- Decide on an appropriate location for your product (see Installation instructions below).
- If you have any doubt about installing this product, consult a qualified electrician.
Installation instructions:
- This standing light is suitable for INDOOR AND OUTDOOR USE.
- The AC adaptor MUST be installed INDOORS away from the weather.
- Do not position or place near heaters or any other direct sources of heat.
- This product is suitable for positioning on surfaces that have normal flammability,e.g.wood, plasterboard, and masonry. However, this does not include highly flammable surfaces(e.g.polystyrene, textiles).
- Always position cables and extension leads so that they will not be a hazard to the elderly, pets, and children.
- DO NOT position this inflatable product where it may become covered by other items e.g. curtains, nets, or bedding.
- Ensure the unit is positioned so that you have enough cable to reach an indoor mains power socket.
Warning
- This standing light is suitable for INDOOR AND OUTDOOR USE.
- This product is NOT designed for permanent or long-term use.
- The AC adaptor MUST be installed INDOORS away from the weather.
- The supplied adaptor is suitable for the operation of LED Modules only.
- Only operate this light set with the supplied adaptor, Model No. JT-DC4.5V3.6W-E4
- Do not connect this standing light electrically to another standing light.
- Do not connect this standing light to the power supply while it is in the packaging.
- If part of a light set or cable is damaged, the light set MUST be discarded.
- This product is for use as a decoration only. Not to be used by children as a toy. Keep out of reach of children.
- Do not position this inflatable product where it will be exposed to extreme wet weather or submerged in water.
- Always switch off this light set or unplug an adaptor if unattended.
- DO NOT overload power sockets or extension leads.
- Please refer to the packing or product rating label for a product class, specifications, and rating.
- DO NOT pierce the cable when securing it in place, bend or stand on the standing light, as this will damage the bulbs or wiring.
LED Bulbs
This standing light is constructed with non-replaceable bulbs. DO NOT attempt
to replace any of the bulbs in the standing light.
Keycode: 43199365
Assembly diagram:
Adaptor Manual
- Please use the equipment according to the rated voltage and current.
Model No.| Input Rated| Output Rated
---|---|---
Voltage| Frequency| Current| Voltage| Power
JT-DC4.5V3.6W-E4| 220-240VAC| 50-60Hz| 0.10A Max| 4.5V DC| 3.6W - Do not open the cover of the equipment.
- For use with LED lighting equipment.
- The input and output voltage should be checked before use to ensure correct use.
- This is a Class II product, only for indoor use.
- The product is not a toy, keep it where children can not reach it.
- The lamp controller does not rely upon the luminaire enclosure for protection against accidental contact with live parts.
- If applicable: an indication that the controller is suitable for operation with LED modules.
- Do-not-cover classification
The power supply that can be used where normally flammable materials.
including building insulation, are or may be present, but cannot be abutted
against any material and cannot be covered in normal.
The minimum clearance distance from the top and sides of the control gear to
the normally flammable building element is 75mm; as shown in the below
picture, A=B=C=Min.75mm.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>