Yealink OPS-A001 OPS Antenna User Guide

Yealink OPS-A001 OPS Antenna

Specifications

• Model : OPS-A001
• Compliance: FCC Part 15, Innovation, Science, and Economic Development Canada license-exempt RSS standards
• Radiation Exposure Limits: FCC/ISED compliant
• Minimum Distance: 20cm between the radiator and the body
• Operating Conditions : Avoid co-location with other antennas or transmitters

Product Usage Instructions

Installation Guidelines

1. Ensure that any changes or modifications are approved by the responsible party to maintain equipment operation authority.
2. Place the device in a location that minimizes interference:

• * – Reorient or relocate the receiving antenna.

  • – Increase separation between equipment and receiver.
  • – Connect the device to an outlet on a different circuit from the receiver.

Operation Guidelines

1. Ensure the device does not cause harmful interference.
2. Accept any interference received, including that which may cause undesired operation.
3. Maintain a minimum distance of 20cm between the radiator and your body during operation.
4. Do not co-locate or operate this transmitter with any other antenna or transmitter.

FAQ

• Q: What should I do if the device is causing interference?
• A: Try reorienting the antenna, increasing separation from other devices, or consult a professional for assistance.
• Q : Is it safe to operate the device close to my body?
• A: No, maintain a minimum distance of 20cm between the radiator and your body for safe operation.

Package Contents

We recommend that you use the accessories provided or ap­proved by Yealink. The use of unapproved third-party accessories may result in poor performance.

Hardware Component Instructions

Installation

Built-in the Collaboration Board MeetingBoard

series, 55″, 65″, 75″, 86″ etc.

Power on

1. Press the OPS power button to start the OPS after installation completely.
2. MeetingBoard automatically switches to the Windows system at this time

• If MeetingBoard does not automatically switch to the Windows system, Click on the bottom right of the MeetingBoard to switch to the Windows system

We recommend placement of the OPS antenna is ad follows, with the highest signal strength:

• HDMI, the HDMI logo, and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.

5GHz band(W52, W53): Indoor use only
Bande 5 GHz (w52, w53): utilisation intérieure uniquement

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with the Innovation, Science, and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1.  this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.

This equipment complies with FCC/ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator& your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>