Electro Hanan EL3050 Water Boiler User Manual
- June 3, 2024
- Electro Hanan
Table of Contents
Electro Hanan EL3050 Water Boiler
OVERVIEW
HOW TO USE
- Remove all packages before use. There is cleaning oil residue before the first use. (To clean and protect the urn, the manufacturer used food-grade cleaning oil) It is recommended you clean your urn before the first use.
- Fill the urn with water to “MAX” level, boil, discard the water, and then rinse. Repeat the procedure several times to remove any dust, residues, etc., from the urn.
- Turn the lid counter clockwise to open.
- Fill the tank with tap water. Make sure the water is below the “MAX ” water level indicator.
- Replace the lid and turn it clockwise to lock into place.
- Connect the plug and the socket.
- Switch on the heating switch, the “HEATING” pilot lamp will light up and the water starts to heat up, until the water is boiling, close the heating switch to stop heat up. Then switch on the keep warm switch, the “KEEP WARM” pilot lamp will be light up and it shows that the appliance is in the state of keep warm.
- Use the faucet to dispense water.
- When about three cups of water are remaining in the tank, turn the appliance off and unplug it from the electric outlet. Always make sure at least three cups of water are remaining in the tank to prevent a boil-dry accident.
SAFETY CUT OUT
- Urns feature a boil dry protection system, which will switch off the element if the water level is too low. To reset the safety cut out, switch off and unplug the urn and allow it to cool. Empty out the water and press the RESET button underneath the urn. Refill with cold water and switch the urn back on again. The urn will automatically reboil.
- Do not touch metal parts of the urn as they become hot during use.
- Be mindful of hot steam coming from the lid vents.
- Do not leave electrical appliances unattended when in use.
- Always put the urn on a clean, level surface that can withstand the weight of the urn – including water.
- Always switch off and disconnect the urn from the mains supply before cleaning or when not in use.
- NEVER attempt to move the urn when it is full of hot (or cold) water.
- Do not allow the urn to be immersed in liquid.
- Do not attempt to disassemble the urn – there are no user-serviceable parts inside.
- ALWAYS disconnect from the mains supply and allow the water to cool completely before attempting to clean or descale the urn.
- NEVER OVERFILL THE URN.
- Do not allow cold water to sit in the urn for more than 2 days as it could stagnate, which is very unhygienic. Empty the water out completely and refill if the urn has been stood idle over the weekend.
- Your appliance must never be switched on through an external timer or any kind of separate remote control system.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliances by a dedicated person who has been trained and qualified.
- Children should be supervised to ensure that they do not play with the appliance.
POWER SUPPLY
- If the unit uses a mains supply, ensure that the plug is securely inserted into the mains socket and it is easily accessible.
- Protect the power lead from sharp objects, excessive heat and damp or wet locations. Check the power lead periodically, and replace if damaged.
- Check that the voltage on the rating plate of your product corresponds with your local electricity supply which must be A.C. (Alternating Current).
- Any repairs should only be carried out by a fully qualified electrician or an authorized service agent.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
ELECTRIC CIRCUIT DIAGRAM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>