CRAZON TJ24161B Stunt Light Drifting Car Instruction Manual

June 1, 2024
CRAZON

CRAZON TJ24161B Stunt Light Drifting Car

CRAZON-TJ24161B-Stunt-Light-Drifting-Car-PRODUCT

Product Operation Manual

Thank you for choosing our product! Please read this instruction manual carefully before using it, as it contains all the information you need to know about how to use this product correctly with fun.
Colors And Contents May Vary From Instri.

STUNT LIGHT DRIFTING CARCRAZON-TJ24161B-Stunt-Light-Drifting-Car-FIG-
\(1\)

  • Colourful light
  • Can swing from side to side
  • Energy drift

Battery Installation

CRAZON-TJ24161B-Stunt-Light-Drifting-Car-FIG-
\(2\)

Battery Included BCRAZON-TJ24161B-Stunt-Light-Drifting-Car-FIG-
\(3\)

  1. Open the battery cover of the RIC car, install a 7.4V rechargeable battery pack, and fasten the cover.tum the switch to ‘ON•
  2. Open the battery cover of the transmitter,
  3. Instal 2×1.5V”AA” batteries, fasten the cover, turn the switch to ‘ON’

The Basic Operation of The Products

CRAZON-TJ24161B-Stunt-Light-
Drifting-Car-FIG- \(4\)

  1. Please turn on the switch in the chassis and then make decoding to start the car.
  2. Push or pull the trigger of the transmitter to make the car go forward or backward.
  3. Turning the transmitter on the steering wheel clockwise causes the car to lean right and turn right
  4. Turning the transmitter on the steering wheel counterclockwise causes the car to lean left and turn left

Press the switch, and the coloured lights come on

  • Charge by USB : About 2.5 hours
  • Playing Time : About 25 Mins;
  • Control Distance : About 25M;
  • Battery capacity and Voltage :500MAH,7.4V

Frequency bands: 2405MHz-2475MHz;
Max output power: -1.88dBm(0.65mW)

BATTERY SAFETY

  1. The placement or replacement of batteries is to be performed by an adult.
  2. Remove the rechargeable battery from the chassis before charging.
  3. Always remove exhausted batteries from the car and the transmitter,
  4. Make sure the main switch is set to OFF before installing the Barbery pack into the car body,
  5. Batteries must be inserted with the correct polarity.
  6. Non-chargeable batteries shall not be recharged.
  7. Do not short-circuit the batteries.
  8. Always remove the batteries from the car and the transmitter after playing
  9. Never throw the batteries into fire to avoid explosion or leakage.
  10. Do not mix batteries from different producers or new and old batteries.
  11. You should only use batteries of the same or equivalent types as recommended.
  12. Check the batteries regularly to avoid leakage.
  13. Keep this manual well for future reference as it contains Important information about this product,

FCC Compliance Statements

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals