CRAZON ZD2305 Drift Stunt Car Instruction Manual

**CRAZON ZD2305 Drift Stunt Car Instruction Manual

**

Thank you for choosing our product! Please read this instruction manual carefully before using, as it contains all the informations you need to know about how to use this product correctly with fun.

Colors And Contents May Vary From Illustration.

Battery Installation

1. Take out the cover of R/C car, instal 7.4V rechargeable battery pack, fasten the cover,turn the switch to ‘on ‘
2. Open the battery cover of transmitter, instal two 1.5VAA batteries , close the cover.
3. The charging time is about 2.5 hours support about 15 minutes playing.
   

The Basic Operation of The Products

1. Go forward and turn right/ Go forward an turn left.
   Go backward and turn right / Go back ward and turn left.
   

2. Forward/ Backward
   

3. 360º Spin
   

4. Slide To Left/ Slide to right
   

5. Slide to left front/ Slide to right front
   Slide to left rear/ Slide to right rear

6. Switch on the light in the housing

The car can adjust the Angle of each joint to achieve multiple shapes.

Charge by USB: About 2.5 hours(for B version)；
Playing Time: About 15 Mins；
Control Distance: About 30M；
Electric current and Voltage: 500MAH, 7.4V；

BATTERY SAFETY

1. The placement or replacement of batteries is to be performed by an adult.
2. Remove the rechargeable battery from the chassis before charging.
3. Always remove exhausted batteries from the car and the transmitter.
4. Make sure the main switch is set to OFF before installing the battery pack into the car body.
5. Batteries must be inserted with the correct polarity.
6. Non-chargeable batteries shall not be recharged.
7. Do not short-circuit the batteries.
8. Always remove the batteries from the car and the transmitter after playing.
9. Never throw the batteries into fire to avoid explosion or leakage.
10. Do not mix batteries from different producers or new and old batteries.
11. You should only use batteries of the same or equivalent types as recommended.
12. Check the batteries on a regular basis to avoid leakage.
13. Keep this manual well for future reference as it contains important information about this product.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This is device may not cause harmful interference, and This device must accept any interference received, including interference thatmay cause undesired operation.
2. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

2.4G Scale 1: 18 Foldable Drifting Wheels RC Off-Road
ITEM NO: 333-ZD2305
Operating Frequency: 2410MHz-2473MHz
Maximum output power: 3.78dBmDeclaration for EU Compliance）

First Creative Products International
Head Office:1236 South Negley Avenue,Pittsburgh,PA 15217,USA
Tel:1-412-521-2237
Fax :1-412-521-2008
Website: www.creativeproductsintl.com

References

• About Creative Products International

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>