CRAZON 333-YC21121 Smoking Punk Remote Control Car Speed Vehicle Toy User Manual
- June 6, 2024
- CRAZON
Table of Contents
CRAZON 333-YC21121 Smoking Punk Remote Control Car Speed Vehicle Toy
Product Operation Manual
Thank you for choosing our product! Please read this instruction manual carefully before using it, as it contains all the information you need to know about how to use this product correctly with fun.
Battery Installation
- Take off the battery cover of the RIC car, install a 7.4V rechargeable battery pack, fasten the cover. tum the sWitch to ‘on’
- Open the battery cover of the transmitter, install 2×1 .5V’AA” batteries, close the cover.
- The charging time is about 3.5 hours support about 25 minutes playing.
The Basic Operation of The Products
- Please turn on the switch under the car and then make decoding to start the car.
- Push or pull the bigger of the transmitter to make the car goes forward or backward. (Push or pull it slowly in order to prevent the car runs out abruptly).
- With the clockwise rotation of the steering wheel on the transmitter, the car will tum right.
- With the counterclockwise rotation of the steering wheel on the transmitter, the car will tum left.
- Smoking Waler-Adding Instruction
SPECIFICATION
- Charge by USB: About 3.5 hours(for version B);
- Playing Time: About 25 Mins;
- Control Distance: About 25M;
- Electric current and Voltage: 1200MAH, 7.4V;
BATTERY SAFETY
- The replacement,.aeement of battec1es Is to be performed by an act.
- Remove the rechargeable battery from the chassis before charglr1g.
- Always remove exhausted batteries. from the Iha car and Iha transmitter.
- Make sure the main switch is set to OFF before installing the battery pack in the car body.
- Batteries must be Inserted with 111a correct polarity.
- Non-chargeable batteries Shan not be recharged.
- Do not short-circuit the batteries.
- Always remove the batteries from the car and the transmitter after playing
- Never throw the batteries into fire to avoid explosion or leakage
- Do not mix batteries from different producers or new and old batteries.
- You should only use batteries same or equivalent types as recommended
- Check the batteries on a regular basis to avoid leakage.
- Keep this manual wen fur fll1ln referance• as it contains Important information a.bout this product.
FCC compliance statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that. at interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>