CORRO-PROTEC 66485461 Anti Corrosion Protection For Suburban Water Heater Installation Guide

CORRO-PROTEC 66485461 Anti Corrosion Protection For Suburban Water Heater

FOR YOUR RECORDS

• Anode Rod Serial Number: —————————–
• Serial numbers can be found on the top of the anode rod stainless steel part.
• Water Heater Serial Number:- ——————————-

READ THIS MANUAL

• Inside you’ll find many helpful hints on how to install and maintain your Corro-Protec anode rod.
• You’ll find several answers to common questions in the FAQ section at the end of this document.
• If you have general questions about the Corro-Protec anode, you can visit our website www.corroprotec.com/faq, or contact us at info@corroprotec.com

READ THE SAFETY INFORMATION

• Your safety and the safety of others are very important. There are many important safety messages in this manual and on your appliance. Always read and obey all safety messages.
• This is the safety alert symbol. Recognize this symbol as an indication of Important Safety Information! This symbol alerts you to potential hazards that can kill or hurt you and others.
• All safety messages will follow the safety alert symbol and either the word “DANGER”, “WARNING”, “CAUTION” or “NOTICE”.

These words mean:

• DANGER An imminently hazardous situation that will result in death or serious injury.
• WARNING A potentially hazardous situation that could result in death or serious injury and/or property damage.
• CAUTION A potentially hazardous situation that may result in minor or moderate injury.
• NOTICE Attention is called to observe a specified procedure or maintain a specific condition.

IMPORTANT SAFETY INFORMATION

READ ALL INSTRUCTIONS BEFORE USING.

• For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life.
• Be sure to read and understand the entire Use and Care Manual before attempting to install or operate this powered anode rod. It may save you time and cost. Pay particular attention to the Safety Instructions.
• Failure to follow these warnings could result in serious bodily injury or death. Should you have problems understanding the instructions in this manual, or have any questions, STOP, and get help from a qualified service technician, or the local electric utility.

SAFETY PRECAUTIONS

• Read this manual entirely before installing or operating the water heater.
• Use this appliance only for its intended purpose as described in this Use and Care Manual.
• Be sure your appliance is properly installed under local codes and the provided installation instructions.
• DO NOT attempt to repair or replace any part of your powered anode rod unless it is specifically recommended in this manual. All other servicing should be referred to a qualified technician.

TOOLS REQUIRED

1. Teflon tape
2. Universal pliers
3. Ratchet wrench with a 1 1/16” socket
4. Ratchet wrench with a 31mm socket (you can also use an adjustable wrench or a 1 3/16 socket)
5. Robertson screwdriver (squared-headed)

INSTALLATION STEPS

• NEED ASSISTANCE?
  • Email us: info@corroprotec.com
  • Call us or text us: 1-877-466-6660

1. Turn off power supply.(120v and Battery)
   • CAUTION ELECTRICITY
2. Turn off the water supply.
3. Locate the water heater outside of the RV.
4. Remove the magnesium rod using a 1 1/16 socket.
   • CAUTION HOT WATER HOT SURFACE
5. Cover the lower part of the screwable anode with Teflon tape.
   • Apply 5-6 layers of teflon tape counterclockwise.
6. Insert the Corro-Protec.
7. Using the ratchet wrench fitted with a 1 3/16 socket, screw the anode clockwise.
   • NOTICE DO NOT USE EXCESSIVE FORCE WHEN TIGHTENING.
8. Insert the female connector in the exceeding end-piece of the anode and press firmly using the universal pliers.
9. Install the black grounding connection on one of the tank screws.
10. Connect the Corro-Protec power supply to the 110v outlet.
11. Turn on the water supply and make sure the tank is full.
12. Turn on the power supply. (120v and Battery)
    • The light located on the rectifier will automatically light up after a couple of seconds.
    • If the Green light doesn’t turn ON:
    • To ensure that the Corro-Protec works, the following conditions must be met:
    • The rectifier must be connected.
    • Corro-Protec must be connected to the rectifier.
    • The negative side must be installed on the water heater, as indicated in the instruction manual.
    • The water heater must be functional (filled and operational).
    • If the above conditions are met and the indicator light is not lit, please visit corroprotec.com/warranty-claim
13. Register your Corro-Protec anode to activate the 20 years warranty at corroprotec.com/warranty

MAINTENANCE

• Corro-Protec recommends inspecting your anode yearly to make sure the green light is on.
• A green light on the power supply means everything is working as it should and your tank is protected.

FAQ

Frequently asked questions

What is the annual power consumption of a Powered Anode Rod?

Since the amount of current used by the anode will vary from region to region due to the hardness of the water, it is impossible to give an exact answer.
However, on average, the anode will use 10 KWh per year. If we take the average price of electricity in the United States, the cost to run the anode 24 hours a day all year round is $ 1.36.

Is it normal to read a voltage lower than that indicated on the Powered Anode rectifier?

Yes, because the voltage adjusts automatically depending on the resistance of your water. A very low voltage means that your water is very conductive and the anode does not need to send much current to provide adequate protection.

LIMITED WARRANTY

What does this limited warranty cover?

• Corro-Protec warrants this powered anode system against defects in material or workmanship for twenty years when installed in a single-family residence. If this part is installed in any location other than a single-family residence, the warranty period is reduced to 2 years. This warranty sets forth the owner’s only remedy and our sole responsibility concerning any defect in this part.
• During the warranty period, Corro-Protec will repair or replace, at no charge, products or parts of a product that prove defective because of improper material or workmanship, under normal use and maintenance.

What will we do to correct problems?

• Corro-Protec will either replace or repair the product at no charge, using new or refurbished replacement parts.
• If an identical part is no longer available due to a change in law, regulation, or standard, we will replace the part with one that has similar functionality.

How long does the coverage last?

• The limited warranty period for physical goods purchased from Corro-Protec is 20 years from the date of purchase when installed in a single-family residence.
• A replacement physical good or part assumes the remaining warranty of the original physical good or 90 days from the date of the replacement or repair, whichever is longer.

What does the limited warranty not cover?

• This limited warranty does not cover any problems that are caused by Conditions, malfunctions, or damage not resulting from defects in material or workmanship.
• Improper installation or maintenance.
• Failure to follow applicable codes and/or printed instructions.
• Alterations to the anode or the power supply.
• Failure to operate the part at the specific voltage/wattage.
• Damage during shipping, transport, or installation.
• Abuse, misuse, accident, fire, flood, or acts of God.
• Service trips to teach you how to install, use, or maintain the part.
• The water heater itself or any of its components are not part of the Corro-Protec product.
• THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED TO THE APPLICABLE DURATION OF THIS WARRANTY. ALL OTHER WARRANTIES ARE EXPRESSLY DISCLAIMED.
• IN NO EVENT SHALL WE BE LIABLE FOR ANY CONSEQUENTIAL, INCIDENTAL, SPECIAL, PUNITIVE, OR OTHER DAMAGES, WHETHER LIABILITY IS BASED ON TORT, CONTRACT, STRICT LIABILITY, OR ANY OTHER THEORY.
• Some states or provinces do not allow the limitation and/or the above exclusion on how long implied warranties last, or do not allow for the exclusion of incidental or consequential damages, so the above limitations may not apply to you.
• This warranty gives you specific legal rights and you may also have other rights, which vary on location.
• CORRO-PROTEC
• 40, Boulevard Industriel, Princeville, Quebec, G6L 4P2
• 1-877-466-6660
• info@corroprotec.com
• CORROPROTEC.COM

Documents / Resources

| CORRO-PROTEC 66485461 Anti Corrosion Protection For Suburban Water Heater [pdf] Installation Guide
66485461 Anti Corrosion Protection For Suburban Water Heater, 66485461, Anti Corrosion Protection For Suburban Water Heater, Corrosion Protection For Suburban Water Heater, Protection For Suburban Water Heater, Suburban Water Heater, Water Heater
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>