KOHLER 1524106-2-A Medicine Cabinet Instruction Manual
- June 9, 2024
- Kohler
Table of Contents
Installation Instructions
Medicine Cabinet
1524106-2-A Medicine Cabinet
Record your model number:………………….
Thank You for Choosing KOHLER
Need help? Contact our Customer Care Center.
- USA/Canada: 1-800-4KOHLER (1-800-456-4537) Mexico: 001-800-456-4537
- Service parts: kohler.com/serviceparts
- Care and cleaning: kohler.com/clean
- Patents: kohlercompany.com/patents
Warranty
This product is covered under the KOHLER® One-Year Limited Warranty, found at kohler.com/warranty. For a hardcopy of warranty terms, contact the Customer Care Center.
Tools and Materials
Plus:
- Assorted Drill Bits
- Framing and Drywall Tools
- Framing and Drywall Fasteners
Before You Begin
CAUTION: Risk of personal injury. This product is very heavy. Get
assistance lifting and moving the product.
CAUTION: Risk of product or property damage. The location of the cabinet
is critical. Verify that the door will clear all obstacles (such as a faucet
or light fixture). Verify that any obstacles behind the finished wall will not
be damaged during the cutting and/or drilling process.
IMPORTANT! Reroute any electrical wires or water supply piping. If you
encounter drain or vent piping or if your wall is load-bearing, consult a
professional before
proceeding.
Follow all local building codes.
This medicine cabinet is for recessed- or surface-mount installations. Follow
the instructions that apply to your chosen installation.
Your product may appear different than the one illustrated. The installation
procedure is the same.
Two people should perform this installation.
When determining the height of the product, verify the door(s) will clear all
obstacles (such as a faucet or light fixture). A minimum distance of 3″ (76
mm) is required.
Prepare the Site
- Use tape to attach the template (provided) to the installation location.
- When determining the height of the product, verify that the door will clear all obstacles (such as a faucet or light fixture). A minimum distance of 3″ (76 mm) is required.
- Surface-Mount: Mark the position of the mounting bar according to the template. Mark the stud locations.
- Recess-Mount: Mark the cutout according to the template.
Surface-Mount – Install the Mounting Bar
- Use a 3/16″ drill bit to drill three holes on the groove of the mounting bar. One hole must be positioned on a stud location.
- Align the mounting bar on the template.
- Mark hole locations on the wall.
- Drill holes at the marked locations on the wall.
- Insert anchors (not provided) where needed.
- Secure the mounting bar with two 2″ hex head screws (provided) or screws provided with the anchors.
Surface-Mount – Hang the Cabinet
NOTE: Rotate the cabinet for right or left door swing.
- Slide the hanger hooks onto the top T-slot as shown.
- Position each hook 2″ (51 mm) from the ends of the cabinet.
- Lift the cabinet onto the mounting bar.
- Verify that the hooks engage the mounting bar.
Surface-Mount – Secure the Cabinet
- Slide a clip onto each end of the top T-slot.
- Verify that the cabinet is centered as desired.
- Drill pilot holes into the wall.
- If needed, insert anchors into the wall.
- Secure the clips with 1-1/2″ screws (provided).
- Slide a clip onto each end of the bottom T-slot.
- Position each clip 2″ (51 mm) from the ends of the cabinet.
- Drill pilot holes and secure with 1-1/2″ screws (provided).
Surface-Mount – Install the Side Panels
- Align the side panel brackets with the mounting holes.
- Secure each side panel with two screws (provided).
- To install the shelves, see the “Install the Shelves” section.
Recess-Mount – Construct the Framing
- Use a jigsaw or keyhole saw to carefully remove the finished wall material from the marked cutout location.
- Frame out the wall cavity. If needed, install a header.
- Secure the drywall to the framing.
Recess-Mount Installation
NOTE: Rotate the cabinet for right or left door swing.
- With help, lift and hold the cabinet in the cutout.
- Verify that the cabinet is level.
- Identify the two mounting holes on each side of the cabinet.
- Secure the cabinet to the framing using the four screws (provided).
Install the Shelves
- Determine the shelf locations and insert the slotted pins into the holes in the sides of the cabinet.
- Install the shelves between the slots of the pins.
USA/Canada: 1-800-4KOHLER
(1-800-456-4537)
Mexico: 001-800-456-4537
kohler.com
©2022 Kohler Co.
1524106-2-A
Documents / Resources
|
KOHLER 1524106-2-A Medicine
Cabinet
[pdf] Instruction Manual
1524106-2-A Medicine Cabinet, 1524106-2-A, Medicine Cabinet, Cabinet
---|---
References
- Toilets, Showers, Sinks, Faucets and More for Bathroom & Kitchen | KOHLER
- How to Use KOHLER Cleaning Products | KOHLER
- Kohler Warranty Info: Product Limited or Warranty | KOHLER
- Kohler Co. Portfolio | Innovation and Design | Patents | Kohler | Kohler
- Toilets, Showers, Sinks, Faucets and More for Bathroom & Kitchen | KOHLER
- Kohler Co. Portfolio | Innovation and Design | Patents | Kohler | Kohler
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>