XTM FS8553S Fridge Slide With Table Large Instruction Manual
- June 1, 2024
- XTM
Table of Contents
+ FRIDGE SLIDE WITH TABLE
LARGE
Instruction Manual
+ Part List
| General Information
External size: L89.5 x W57.7 x H9.5cm
Internal tray size: L85 x W53 x H3.4cm
Net weight: 25kg
---|---
| + Mounting Kit
6 x M6 washers
6 x M6 tee nuts
6 x M6 x 20mm bolts
6 x M6 nyloc nuts
| + Tie Down Kit
4 x nylon strapes
+ Preparing for the Fridge Slide install
Fridge slide needs to be installed on a flat even surface with a minimum of 12
mm thickness.
You will require the use of an electric drill to install the slide.
| 
---|---
+ Pull out the sliding tray by depressing the locklevers on both sides, then
pull sliding tray forward to reveal the fixing holes on the side rails.| +
Mark the six drilling points through the fixing holes with a permanent marker.
| 
+ Drill six 7mm holes for the Tee Nuts.| + Insert the Tee Nuts into the
holes ensuring the nuts are upright and square to the hole.
| 
+ Flatten the Tee Nuts with a mallet or hammer.| + Position the fridge slide
on the flat surface.
Use the 6 x M6 bolts to fix to the surface.
+ Tie Down the Fridge
Secure your fridge on the sliding tray by using the 4 nylon straps supplied. Make sure the straps are tight and secure.
+ Important Notes
- The fridge slide must be securely and evenly bolted down to the floor of the vehicle or to wherever the slide is to be used.
- Under no circumstances can the slide be used other than when it is fixed down correctly on a smooth even surface with no contortion of the frame.
- The sliding tray is activated by depressing the both sides levers on the front to pull forward and lock in.
- Heavy pushing without depressing the lever will result in damage to the lever.
- Ensure that the tray is firmly locked into place when returning the tray to its inward position.
- This fridge slide is designed to carry fridges up to 80kqs including contents and the sliding table with 15kg capacity. It is not recommended for commercial use and no warranty applies if used so.