OPTION SPS200 Spot-On Parking Sensor Installation Guide
- June 12, 2024
- OPTION
Table of Contents
OPTION SPS200 Spot-On Parking Sensor
Product Information
The Spot-On Parking Sensor (SPS) is a device designed to assist in parking by providing proximity detection. It helps drivers toavoid collisions and park their vehicles safely.
Installation Guide
To install the SPS parking sensor, follow the steps in this guide
-
Labels: Before installing the parking sensor, it is recommended to take a picture of the sticker at the bottom of the device or remove the sticker and place it on a map. This will help you easily link devices with their location in the future.
-
Device Placement: Place the sensor in the center of the parking slot to ensure optimal detection. Make sure the surface is flat, even, and free of gaps as much as possible to avoid any potential damage to the casing or electronics.
-
Mounting the Device into place: You can use an empty casing to position the holes or mark the hole locations and then remove the sensor. It is recommended to use special anti-vandalism screws to secure the device in place. The diameter of the screws used should not exceed 6mm.
-
Power On the device: Please refer to the document “ Spot_On_NFC_Manual ” for instructions on how to configure and power on the SPS parking sensors using the NFC TagWriter from NXP. The The NFC TagWriter app is available on:
-
Label Example
-
Installation Example
-
Mounting Example
NOTE: CRESCENT NV Geldenaaksebaan 329 3001 Leuven Belgium www.option.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>