3DMakerpro 3D Printers FEPshop Scanner Whale Premium Instruction Manual
- June 1, 2024
- 3DMakerpro
Table of Contents
3DMakerpro 3D Printers FEPshop Scanner Whale Premium
Computer Requirements
- Minimum: Intel Core i5 8th, 16GB RAM, MX250 GPU with 2GB VRAM
- Recommended: Intel Core i7 8th, 16GB RAM, NVDIA1060 GPU with 4GB VRAM
HARDWARE CONNECTION
One end of the device is plugged into the navigation plug, and the other side is plugged into the power cord and computer USB 2.0 or above port respectively.
Device Cable
Insert the power plug at the device end by aligning the raised point with the
interface dot mark.
Pull the cord on the plug when pulling it out.
Turntable Cable
The turntable power cord can be plugged into the computer through usb power supply, or use the phone charger for its power supply.
PACKING LIST
Not included in the standard package.
WARNING: To prevent antivirus software from blocking the driver, please
uninstall the antivirus software.
3DMakerpro
- @3DMakerProCares
- @official3DMakerPro
- @3DMakerPro
- https://store.3dmakerpro.com/
- service@3dmakerpro.com
JimuMeta
- JimuMeta
- JimuMeta
- https://www.jimumeta.com/
- service@jimumeta.com
SCANNER
Copyright © 2022 Shenzhen
jimuyida Technology Co., Ltd. All rights reserved.
store.3dmakerpro.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>