traulux SMMI-ROST-VC Mobile Floor Stand for Monitor Instruction Manual

traulux SMMI-ROST-VC Mobile Floor Stand for Monitor.

• Read the entire instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor for assistance.

CAUTION

• Use with products heavier than the rated weights indicated may result in instability causing possible injury.
• Please closely follow the assembly instructions. Improper installation may result in damage or serious personal injury.
• Safety gear and proper tools must be used. This product should only be installed by professionals.
• Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
• Use the mounting screws provided and DO NOT OVER-TIGHTEN mounting screws.
• This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
• This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.

Required for Installation

Component Checklist

IMPORTANT: Ensure that you have received all parts according to the component checklist before installation. If any parts are missing or faulty, contact your place of purchase for a replacement.

Package M

Assembling

1. Assembling the Base
   • Attach the right base to the middle base and secure with screws(U). Repeat this step for the left base.
   • NOTE: Lock the brakes on the casters to avoid any unexpected movements during installation. Each caster can be adjusted independently for fine-tuning. Slightly turn the nut to lower or raise the base.
2. Attaching the Columns to the Base
   • Pull the pin outwards and pull the inner column upwards at the same time, until the inner column is pulled to the desired height then release the pin to secure.
3. Installing the Crossbar
4. Installing the Cable Covers
5. Installing the Universal Plate
6. Installing the Adapter Brackets
   • 6a. For Flat Back Screens
   • 6b. For Screens with Irregular Back
   • Note: Choose the appropriate screws, washers and spacers (if necessary) according to the type of screen.
   • Position the adapter brackets as close as possible to the centre of the display.
   • Screw the adapter brackets onto the display.
   • Tighten all screws but do not over-tighten.
7. Hooking the Display onto the Universal Plate
   • Hook them onto the universal plate.
   • Tighten the bottom screws to secure them.
   • IMPORTANT: Make sure the display is mounted correctly and the screws are tightened safely before releasing the display.
8. Installing the Camera Shelf
9. Installing the DVD Shelf
   • Install the support bar to the columns at the desired position and secure using the appropriate screws.
10. Cable Management
11. Adjustment
    • It is recommended to adjust the columns to the desired height before installing the display.
    • If you want to adjust the column’s height after finishing the display installation. Please remove the DVD shelf, then adjust the columns to the desired height.

Maintenance

• Check that the bracket is secure and safe to use at regular intervals(at least every three months).
• Please contact your distributor if you have any questions.

MORE INFO

MODEL NO: SMMI-ROST-VC

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>