XGIMI X-Floor Projector Stand Tripod User Guide
- June 15, 2024
- XGIMI
Table of Contents
XGIMI X-Floor Projector Stand Tripod
Floor Stand Ultra
- Please carefully read the product specifications as well as the operating precautions before using this product.
- We highly appreciate you purchasing and using products produced by XGIMI Tech Co .. Ltd.
- (also known as “”XGIMI Tech”” or “”XGIMI””). Before using this product. please read the product specifications for your safety and benern. XGIMI Technology will not be accountable for any personal injury, property damage,
- or other losses resulting from your failure to comply with these terms.
- About the Product Specifications (also known as “the specification”) XGIMI Technology has reserved all of the specifications· copyrights. All of the trademarks and brands mentioned in the specification belong to their respective owners.
- If there is any inconsistency between the specification and the actual product the actual product will prevail.
- Any objections to any content or clause found within the specification should be reported in writing to XGIMI Technology within 7 days after the purchase. Otherwise, it will be assumed that you agree with, understand, and accept all the specification’s content.
Product Components
- Gimbal Support Rod x 1
- Quick Release Gimbal (Module A) x 1
- Auxiliary Threader x 1
- Basex1
Installation
- Rotate the base cover counterclockwise as indicated on the base itself and remove the cover.
- Pull the DC power cord (connected to the
- Pull the DC cord through the base cover hole. Place the base cover on top and rotate it clockwise as indicated on the base itself to secure it.
- Insert the DC cord into the auxiliary threader.
- With the gimbal support rod unexpended, put the DC cord in from inside the rod (starting at the bottom) and out its opening (at the top). l
- Align and insert the gimbal support rod into the base hole. Twist the fastening knob clockwise to tighten.
- Loosen the height adjustment ring. Then adjust the gimbal support rod head to the proper height. After, tighten the height adjustment ring. ,
- Align the threaded hole at the bottom of the projector with the screw on module A and screw it clockwise to tighten.
- Secure module A into module B, located on the quick release gimbal. Screw module A into module B clockwise to finish the installation.
- Adjust gimbal module C to achieve an appropriate projected image (based on your needs). Tighten the knob clockwise to finish adjustment.
XGIMI Technology Co .• Ltd
Building A4, No. 1129 Century City Road, New and High-tech zones, Chengdu City China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>