IDD Parts TorQtool 2 Overhead Doors And Docking Systems Spare Parts User Manual

: June 1, 2024
: IDD Parts

Table of Contents

Congratulations
Maintenance
Check before use
During use
Instruction For Use
Declaration of Conformity
Bracket
Customer Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

IDD Parts TorQ tool 2 Overhead Doors And Docking Systems Spare Parts

IDD Parts TorQ tool 2 Overhead Doors And Docking Systems Spare
Parts

Congratulations

Congratulations on your purchase! Before you start, read this manual carefully and watch the video on YouTube. We recommend practicing with the tool in a test environment. Please contact IDD-Parts or your supplier if anything is unclear or you have any questions.

Please note! General warnings!

A number of precautions must be taken to use, operate and maintain this torQtool 2. For safety reasons, observe the warnings
and instructions below.

The torQ tool 2 is intended for tensioning torsion springs of overhead doors. Never use the torQ tool 2 for any other purpose.
The torQ tool 2 is intended for qualified professionals and unsuitable for DIY or use by trainees.
This manual explains how to use and maintain the torQtool 2.
All safety warnings and notes applicable to the installation of the complete sectional overhead door must be observed.
Never exceed the maximum torque of 300Nm.
The warranty is void if parts are added or changed without consulting the manufacturer.
The springs can come under great stress when being tensioned. Make sure you are in a stable position when using the tor Qtool 2. Also make sure your body is not in line with the torQ tool 2.
Make sure there is sufficient lighting while using the torQ tool 2.
All rights derived from this manual are reserved. Technical information is subject to change without notice.

Maintenance

Make sure the gears of the torQ tool 2 are lubricated. For this purpose, use PTFE spray (Teflon spray) or another gear
lubricant at least once a month.
Make sure the torQ tool is clean.
Check the torQ tool 2 for damage before using it to tension a spring. Do not use the torQ tool 2 if it is damaged.

Check before use

Make absolutely sure you are about to tension the spring in the right direction! Tightening in the wrong direction could cause dangerous situations and possible injury.
Check the torQ tool 2 for damage before tensioning a spring with the torQ tool 2. Do not use the torQ tool 2 if it is damaged.
Make sure the torQ tool 2 is clean before using it.
Always check the locking mechanism before tightening the spring.
Make sure you use the correct size insert pin on the spring plug before you start tensioning the spring.
Do not exceed the prescribed torque and maximum number of revolutions per minute.
Use the correct 13mm hex cap on your drill to operate the torQ tool 2.
Check that maintenance has been carried out properly before using the torQ tool 2. Keep the gears lubricated.
If in doubt about any of the above points, do not use the torQ tool.

During use

Do not use an impact drill. Only use a normal (battery) screw driver.
Make sure you are tensioning the spring in the right direction. If you discover that you are tensioning the spring in the wrong direction, the best way to relax the spring is to rotate the torQ tool 2 in the opposite direction. In such a case, always replace the spring with a new one.
If you are using a scissor lift while tensioning the springs with the torQ tool 2, never lower the scissor lift before the spring plugs are properly secured to the shaft.
The torQ tool 2 should never be used to overtighten a door. Dangerous situations can arise when too much force is applied to the spring plug.
Never dismantle the tool if the spring plug is not yet fixed on the shaft.
Do not allow yourself to be distracted while tensioning springs.