TOUCHBeauty TB-1859 Heated Eyelash Curler Instruction Manual
- June 1, 2024
- TOUCHBeauty
Table of Contents
TOUCHBeauty TB-1859 Heated Eyelash Curler Instruction Manual
Safety Instructions
To ensure proper operation of this device, please read this instruction manual carefullybefore using the device and keep it for further reference.
WARNING
- This device is not a toy, keep out of reach of children.
- Please verify the device before you start using it. Do not use if there is anydamage.
- Please, keep the USB cable and the device charging port dry.
- Do not use the device while charging.
CAUTION
-
The following persons should not use this device: persons with allergies;
persons with wounds, inflammation, and swollen eyes; persons with eye- relateddiseases, such as conjunctivitis, etc. -
This device is not intended for use by persons (including children) withreduced physical, or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning the use of the devicebya person responsible for their safety. -
Do not use the device while you are wearing contact lenses.
-
Immediately stop using the device and consult a doctor if you feel any
discomfort in the eyes. -
Keep the device out of reach of children.
-
Regularly clean the device body and accessories to extend its lifetime.
-
Do not share the same device with others.
-
Do not attempt to disassemble, repair, or modify the device by yourself toavoid accidents.
-
This device has a lithium battery. Do not place or store the device for longperiods under a hot or humid environment. If you do not intend to use the device for a long time, store it after it is fully charged. Do not throw the device into a fire or put it in the general household waste. Please dispose of this device in an official recycling point.
Model No.: TB-1859
Input: 5V /0.5A
Power: 3.7V /2.2W
Type of Battery: Li-ion 3.7V 320mAh
Executive Standard: Q/XMMJ1005-2015
Device Description
- Protective Cap
- Big Heating Comb
- Small Heating Comb
- Temperature Level Indicators
- Power Button
- USB Cable
- USB Charging Port
Preparation Instructions
This device battery is low before use. Please charge the device with the USB
cable beforeyou start using it.
The device has a low battery alarm system. When the battery is low, the device
three
temperature level indicators flash to remind you that the battery is low
Charging Instructions
- Make sure the device is turned off.
- Connect the USB cable to the device’s USB charging port located on the bottom of thDevice. Then plug the adapter into a wall socket (adapter is not included). (Picture 2)
- While charging, the temperature level indicators light up in a cycle.
- When the battery is fully charged, all the temperature level indicators light up continuously. Charging the device takes approximately 2 hours.
- When the battery is fully charged, the device can be used consecutively for about 50minutes.
- When the battery is low, the temperature level indicators will flash. If you need to usethe device shortly, connect the USB cable to a charging socket and do an emergency
charge for approximately 20 minutes (for reference only).
Caution: Do not attempt to replace the device’s battery
How to Use
To ensure the correct operation of this device, please read the instructions carefully before use.
Operating the Device
-
Turn ON/OFF
Press and hold the power button for a few seconds to turn on the device. This device features a smart auto-timer. The device automatically shut down after 5minutes with or without use. You can also press and hold the power button for a fewseconds to turn off the device -
Temperature Level Adjustment
Low-temperature level (first light indicator): 55℃±5℃; medium-temperature level (second light indicator): 65°C±5°C; high-temperature level (third light indicator): 75°C±5°C.
Press the power button to change between temperature levels in a cycle low- medium-high.- This device has a memory function. When you turn on the device, it will assume the last used temperature level.
- Always use the device in front of a mirror to ensure you do not injure the eyes.
- When using the device, the silicone comb will be hot. Do not touch the skin withthe silicone comb for a long time.
- Allow the device to preheat for around 15s.
- The big heating comb is suitable to curl the upper eyelashes, while the small heating comb is suitable to curl the sides of the upper eyelashes and the lower eyelashes
-
Apply mascara on the eyelashes (provides better results). (Picture 3)
-
Remove the protective cover. Press and hold the power button to turn on the device. Allow the heating comb to heat up for around 15 seconds before you start using thedevice.
-
Touch and hold the big heating comb against the root of the upper eyelashes for approximately 3 seconds and comb slowly from the root towards the tip. Holdtheposition for another 3 seconds to curl. Repeat this operation 2-3 times. (Picture 4)
-
Use the small heating comb to curl the sides of the eyelashes.
-
Recommended order of use: upper eyelashes, lower eyelashes.
-
After use, turn off the device and only clean it after the heating comb has cool down
Cleaning & Maintenance
To ensure the best performance of the device, clean it before and after each use.
- Make sure the device is power off before you start cleaning.
- Do not immerse the device in water. Clean the device with a clean slightly wet cloth.
- Clean the silicone heating comb with a clean slightly wet cloth or cotton swab moistened with makeup remover, rinse the heating comb with water and dry it.
- Do not use steel wool, abrasive cleansers, chemicals or corrosive liquids to clean thedevice.
- Do not use lubricants, detergents, polishing agents or air fresheners on this device
Storage
This device has a lithium battery. Do not place or store the device for long periods under a hot or humid environment. If you do not intend to use the device for a long time, store it after it is fully charged.
Recycling
The built-in battery contains substances that may pollute the environment. When disposingof this device, do not put it in the general household waste. Please dispose of this device inan official recycling point to contribute to environmental protection.
Warranty & Support
Troubleshooting
Problem | Possible Cause | Solution |
---|---|---|
The device is not working properly. | The battery is running low or out of | |
power. | Recharge the device as guided. | |
The curling effect is not satisfying. | The heating comb temperature is low. |
Allow the device to heat up for about 15s before you use it again.
Eyelids feel hot when using the device.| You are pressing the heating comb
against the eyelids.| Use the device in front of a mirror to avoid pressing
the heating comb on the eyelids.
Other problems.| | Consult your local dealer.
Note: If the device still does not work properly after using the above
solutions, please stop using the device and contact your local dealer.
After-Sales Service
Please visit our website www.touchbeauty.com or
contact our customer service
teamcustomer@touchbeauty.com if you need to
learn about our products or if you need any information. You can also contact
an affiliate dealer in your country.
MANUFACTURER: TOUCHBEAUTY BEAUTY & HEALTH (SHENZHEN) CO., LTD
ADDRESS: 601 & 602, Block F5, TCL International E-City, 1001 Zhongshanyuan
Road, Shuguang Community, Xili Subdistrict, Nanshan District, Shenzhen, China.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>