BuiltRough BR-FRS-017 Running Boards Instruction Manual

BuiltRough BR-FRS-017 Running Boards

FITS: 2021-Up Ford Bronco 2-Door

Torque & Tools

BEFORE INSTALLATION
REMOVE CONTENTS FROM THE BOX. VERIFY ALL PARTS ARE PRESENT DEPENDING ON THE PARTS LIST. READ INSTRUCTIONS CAREFULLY. THE BUMPER IS HEAVY, ASSISTANCE IS HIGHLY RECOMMENDED TO AVOID POSSIBLE INJURY OR DAMAGE TO THE VEHICLE.

Part List

Rocker Step

PLEASE NOTE THAT THE FOLLOWING PICTURES ARE BASED ON THE PASSENGER-SIDE INSTALLATION

STEP 1
Starting from underneath the Passenger/Right body panel, locate the front mounting location and the threaded holes in the body panel, (Fig 1). Remove the plastic plugs covering the holes.

STEP 2
Select the Passenger/Right Front Mounting Bracket. Attach the Mounting Bracket to the front location with (2) 10mm Hex Bolts, (2) 10mm Lock Washers and (2) 10mm Flat Washers, (Fig 2). Do not tighten the hardware.

STEP 3
Repeat Steps 1-2 to attach (1) Passenger/Right Rear Mounting Brackets to the rear locations, (Figs 3-4). Do not tighten the hardware.

STEP 4
Select the Passenger/Right Rocker Step.

NOTE: The Passenger/Right Rocker Step will have a “17- R” on the front. Carefully place Rocker Step on the brackets. Attach the Rocker Step to the (2) Mounting Brackets with (4) 8mm Combo Bolts, (Fig 5).

Do not tighten the hardware.

STEP 6
Level and adjust the Rocker Step and fully tighten all hardware.

STEP 7
Repeat Steps 1—6 to attach the Driver/Left Rocker Step.

STEP 8
Do periodic inspections of the installation to make sure that all hardware is secure and tight.

Attention
To protect your investment, do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used also to clean the Rocker Step.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>