DOMETIC SL12-100 Power And Control Battery Monitors User Manual

**DOMETIC SL12-100 Power And Control Battery Monitors User Manual

**

Important notes

Please read these instructions carefully and follow all instructions, guidelines, and warnings included in this product manual in order to ensure that you install, use, and maintain the product properly at all times. These instructions MUST stay with this product.

By using the product, you hereby confirm that you have read all instructions, guidelines, and warnings carefully and that you understand and agree to abide by the terms and conditions as set forth herein. You agree to use this product only for the intended purpose and application and in accordance with the instructions, guidelines, and warnings as set forth in this product manual as well as in accordance with all applicable laws and regulations. A failure to read and follow the instructions and warnings set forth herein may result in an injury to yourself and others, damage to your product or damage to other property in the vicinity. This product manual, including the instructions, guidelines, and warnings, and related documentation, may be subject to changes and updates. For up-to-date product information, please visit : documents.dometic.com.

Related documents

Find the installation and operating manual online on qr.dometic.com/be1utB.

Safety instructions

WARNING! Failure to obey these warnings could result in death or serious injury.

• In event of fire, use a fire extinguisher which is suitable for electrical device.
• Do not operate the device if it is visibly damaged.

CAUTION! Failure to obey these warnings could result in death or serious injury.

• Installation, assembly, and wiring as well as all other work may only be performed by qualified electrical specialists. Inadequate repairs may cause serious hazards.
• Installation in potentially explosive areas such as rooms with inflammable liquids or gases is not permitted.
• Do not install or keep the device near flames or other heat sources (heating, direct sunlight, gas ovens etc.).
• Children shall not play with the appliance.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

NOTICE! Indicates a situation that, if not avoided, can result in property damage.

• Check that the voltage specification on the data plate corresponds to that of the energy supply.
• Never immerse the device in water.
• Protect the device and cables against heat and moisture.
• Do not expose the device to rain.
• Make sure that the mounting surface is capable of supporting the weight of the device.
• Lay the cables so that they cannot be tripped over or damaged.
• Use ductwork or cable ducts if it is necessary to lay cables through metal panels or other panels with sharp edges.

Intended use

The 12 DC link manager provides optimal management of heavy duty loads. The device provides risk-free operation of such appliances as an air conditioner, hair dryer and coffee machine, on or off grid. The device is intended to be used with 12 V charging systems and appliances. The device protects the batteries and the electrical system by selecting the safest power source. The device always keeps the starting and the house battery voltage under control, avoiding any overload to the alternator or the electrical system. The maximum constant power consumption of a connected appliance must be below 1500 W. The device is intended to be used in motorhomes, campervans and coaches.

This product is only suitable for the intended purpose and application in accordance with these instructions.
This manual provides information that is necessary for proper installation and/or operation of the product. Poor installation and/or improper operating or maintenance will result in unsatisfactory performance and a possible failure.

The manufacturer accepts no liability for any injury or damage to the product resulting from:

• Incorrect installation, assembly or connection, including excess voltage
• Incorrect maintenance or use of spare parts other than original spare parts provided by the manufacturer
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in this manual

Demotic reserves the right to change product appearance and product specifications.

Target group

The electrical power supply must be connected by a qualified electrician who has demonstrated skill and knowledge related to the construction and operation of electrical equipment and installations, and who is familiar with the applicable regulations of the country in which the equipment is to be installed and/or used, and has received safety training to identify and avoid the hazards involved.

Installation

1. Remove the two screws.

2. Remove the lid.
   Fig. 1 on
   

3. Secure the device on the mounting surface using the included screws.
   Fig. 2 on
   

4. Remove the three M6 nuts.
   CAUTION! Damage hazard
   All cables of power connections must have a minimum cross-section of 25 mm², or in any case, the cross-section must be matched to the required length of the cable.

5. Connect the starting battery positive , the inverter positive and the house battery positive cables .
   Fig. 3 on
   

6. Install and tighten the three M6 nuts.

7. Loosen the two pin terminal screws.
   CAUTION! Damage hazard
   To prevent damage to the equipment, the house battery negative must be connected at the end of the installation.

8. Connect the D+ signal wire to pin and the house battery negative wire to pin .
   Fig. 4 on.
   

9. Tighten the two pin terminal screws.
   NOTE If the device is connected correctly, it should emit an acoustic signal.

10. If the device does not emit an acoustic signal, press the On/Off switch.
    Fig. 5 on.
    

11. Install the lid and secure it with the two screws.

12. If the vehicle is equipped with a smart alternator (Euro-6), bridge connectors and with the supplied
    jumper cable.
    Fig. 6 on.
    
    NOTE Connecting the jumper cable to either of the two connectors activates the smart alternator mode.

Operation

The device is operating automatically without any user interactions required.

Operation with engine running During the trip, when the alternator is operating, the device establishes a direct power supply line between the inverter and the starting battery. This allows the use of the air conditioner of the living side, the coffee machine and all the other appliances without stressing the vehicle charging system. This also keeps the batteries safe from deep discharges. When the engine is idling, or the vehicle accessories are operating, the voltage supplied by the alternator drops and the device activates the economy mode. In this mode the compressor of the air conditioner is switched off via a relay on the control connector. When the power supply from the alternator is restored, the device reactivates the compressor. If even in this condition the alternator fails to meet all energy requirements, the power supply from the house battery is directed to the inverter. When the alternator voltage returns back to optimal voltage range, the power supply is switched back to the starting battery and the air conditioning compressor is reactivated, turning off the economy function.

Operation with engine off

The device allows the use of the inverter connected to the house battery even when the engine is switched off, without risk. When the voltage of the house battery drops below 11.1 V during use, the device will switch into the economy mode. In this mode, the air conditioner fan keeps running, but the compressor is deactivated. This reduces consumption and protects the batteries from deep discharges. If the house battery voltage continues to drop, and reaches 10.5 V, the device continues to reduce consumption by completely isolating the inverter from the batteries. The inverter will only become active again when the house battery voltage reaches normal operating range, or when power supply from the vehicle alternator is detected.

Disposal

Recycling packaging material: Place the packaging material in the appropriate recycling waste bins wherever possible.
Recycling products with non-replaceable batteries, rechargeable batteries, or light sources:

• If the product contains any non-replaceable batteries, rechargeable batteries, or light sources, you don’t have to remove them before disposal.
• If you wish to finally dispose of the product, ask your local recycling center or specialist dealer for details about how to do this in accordance with the applicable disposal regulations.
• The product can be disposed free of charge.

YOUR LOCAL
DEALER AND SUPPORT
ndsenergy.eu
A complete list of Dometic companies, which comprise the Dometic Group, can be found in the public filings of: DOMETIC GROUP AB Hemvärnsgatan 15 SE-17154 Solna Sweden

References

• MDaemon Webmail
• Home

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>