DORMAN 13722 Keyless Entry Remote 4 Button Owner’s Manual
- June 1, 2024
- DORMAN
Table of Contents
DORMAN 13722 Keyless Entry Remote 4 Button
OWNER’S MANUAL
Use this Procedure for Vehicles with Driver Information Center Buttons
This procedure will erase all previously learned transmitters. Therefore, they must be relearned as additional transmitters (STEP 5)
This information is in your Owner’s Manual in the Drivers Information Center Section
1. Insert Key and turn to ON position so you can access Drivers Information
Center
2. Press the vehicles information button until PRESS TO RELEARN REMOTE KEY
displays
3. Press the set/reset button until REMOTE KEY LEARNING ACTIVE displays
4. Press and hold the lock and unlock buttons on the first keyless remote at
the same time for approximately 15 seconds. A chime will sound indicating that
the remote is programmed.
5. To program additional remotes at this time repeat step 3. This vehicle can
have a maximum of eight remotes programmed.
6. To exit programming mode turn key off and remove key. Test remote(s)
Use this Procedure for Vehicles without Drivers Information Center Buttons
To access this display, the vehicle must be in Park (P) with key in the on position (as far as you can go without cranking the engine)
1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for three seconds. The message
REMOTE KEY LEARNING ACTIVE will display
3. Press and hold the lock and unlock buttons on the first keyless remote at
the same time for approximately 15 seconds. A chime will sound indicating that
the remote is programmed.
4. To program additional remotes at this time repeat step 3. This vehicle can
have a maximum of eight remotes programmed
5. To exit programming mode turn key off and remove key. Test remote(s)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>