TAOGLAS EDGE Locate RTK Smart Antenna for Diverse Applications User Guide
- June 1, 2024
- TAOGLAS
Table of Contents
TAOGLAS EDGE Locate RTK Smart Antenna for Diverse Applications
Specifications
- Product Name: EDGE LocateTM
- Manufacturer: Taoglas Group Holdings Limited
- Interface: USB
- Baudrate: 38,400
- Compatibility: Windows PC
Product Usage Instructions
- Download and Install u-center Software
- Download and install the u-center evaluation software from www.u-blox.com/u-center.
- Connect the EDGE Locate
- Connect the EDGE Locate to the provided USB interface board as shown in Figure 1.
- Establish Communication
- Connect the USB interface board to a Windows PC using the provided USB cable. Open u-center and navigate to View > Text Console to view NMEA sentences.
- Install Required Driver
- Start u-center, go to Receiver > Connection, and configure the connection settings. The driver for the USB interface board will install automatically if you have an active internet connection.
- Configure Baudrate
- In the u-center, under Receiver > Baudrate, select 38,400 to establish proper communication with the EDGE Locate.
- Setup Error Correction Service
- To set up an Error Correction Service in u-centre, go to Receiver > NTRIP client and enter the mount point settings provided by your correction service provider.
- Check Fix Mode Status
- Once corrections are received, monitor the Fix Mode status in the Data View. It should change to 3D/DGNSS and eventually to 3D/DGNSS/Fixed if a FIXED RTK solution is available.
For detailed installation instructions, visit Taoglas Support.
USING INSTRUCTION
- Download and install the u-center evaluation software from www.u-blox.com/u-center
- Connect the EDGE Locate and the provided USB interface board as in Figure 1.
- Connect the USB interface board to a Windows PC via the provided USB cable. The driver required to use this interface will install automatically in the background if you have an active internet connection.
- Start u-centre and select the menu item “Receiver” > “Connection” and then the COM port the EDGE Locate is connected to. If there are multiple COM ports listed, you will have to determine the correct one using the Device Manager.
- Under the menu item “Receiver” > “Baudrate” select 38’400. To confirm communication with the EDGE Locate, Select the menu item “View” > “Text Console”, a window should appear displaying NMEA sentences as they are sent from the module.
- To set up an Error Correction Service connection in the u-centre, select the menu item “Receiver” > “NTRIP client…” and enter the mount point settings you have received from your correction service provider. (See included leaflet if trial of corrections service is bundled)
- Once corrections are received the Fix Mode status in the Data View will change to 3D/DGNSS and eventually to 3D/DGNSS/Fixed if a FIXED RTK solution is available.
See
www.taoglas.com/iot-support/: For
detailed installation instructions.
All copyrights, trademarks and any other intellectual property rights related
are owned by Taoglas Group Holdings Limited.
www.taoglas.com
FAQ
(Frequently Asked Questions)
- Q: Who owns the copyrights and trademarks related to EDGE Locate?
- A: All copyrights, trademarks, and intellectual property rights related to EDGE Locate are owned by Taoglas Group Holdings Limited.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>