Grupo Ruz A27872 Animation Train Instructions

Grupo Ruz A27872 Animation Train

REMOTE CONTROL OPERATING INSTRUCTION

• Use a screwdriver to remove the battery cover. (Screwdriver not included)
• Insert 2 “AA” batteries in the polarity shown.
• Put the battery cover back in place.

Operation

• Turn the indicator on the rotary knob to the noon position.
• Short press the ON/OFF button on the remote control. The locomotive will start. Slowly rotate the knob clockwise and the train will begin to move forward.
• As you continue to rotate the knob, the train will increase its speed.
• To slow the speed of the train, slowly rotate the knob counterclockwise. Rotating back to the midnight position will stop the train.
• Continue rotating the knob in the counterclockwise direction to make the train run backwards.
• Press the left button for the train whistle.
• Press the right button to mute or unmute.
• Short press the ON/OFF button at any time to pause the train or resume movement. Press and hold the ON/OFF button on the remote control for 3 seconds to turn off the remote control.

Locomotive

Remote Control

WARNINGS – PLEASE READ CAREFULLY BEFORE USE

• NEVER LEAVE THIS PRODUCT UNATTENDED DURING USE.
• TO AVOID DERAILMENTS BE SURE MOVING PARTS ARE CLEAR OF ALL OBSTRUCTIONS AND ALWAYS PLACE TRACKS ON A HARD FLAT SURFACE.
• INSPECT THE TRAIN AND THE TRACKS BEFORE EVERY USE. IF THERE ARE ANY CRACKS OR BROKEN PARTS, DISCONTINUE USE AND DISCARD IMMEDIATELY.
• USE TRAIN ONLY IN CONJUNCTION WITH THE PROVIDED TRACK.
• ADULT ASSEMBLY AND SUPERVISION REQUIRED AT ALL TIMES.
• BEWARE OF SHARP EDGES AND OTHER FUNCTIONAL SHARP POINTS.

WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

FCC STATEMENT

FCC ID:2BFRYA27872
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, according to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used under these instructions, may cause harmful interference with radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio and television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

INTRODUCTION

• Congratulations on your purchase of the Holiday Express Train.
• Please read all instructions and warnings in this sheet before using your train.
• Keep this instruction sheet as it contains important information for future reference.

CONTENTS

ASSEMBLY

• Adult assembly and supervision are required at all times.
• For the easiest assembly, connect track pieces together on the ground.
• Use 24 curved tracks to assemble a 4-ft circle.
• Use 24 curved & 20 straight tracks to form a 9-ft oval track.

• Remove demo batteries and install new batteries.
• Use a screwdriver to remove the battery cover on the back of the locomotive. (Screwdriver not included)
• Insert 4 “AA” batteries in the polarity shown.
• Put the battery cover back in place.
• Place cars and locomotives on top of tracks.
• Connect them as shown above.

BATTERY WARNING

• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Insert batteries using the correct polarity. Do not short-circuit the supply terminal.
• Remove batteries when not in use. Recycle or dispose of exhausted batteries according to federal, state, and local laws. Do not dispose of batteries in a fire, as they may leak or explode.
• Only use a manufacture-specified battery(ies), charger(s) and/or adapter, if applicable, specified by the manufacturer.
• Always use, replace, and recharge (if applicable) batteries under adult supervision.

KEEP THIS PACKAGE FOR REFERENCE AS IT CONTAINS IMPORTANT INFORMATION

• Make sure the lip of all of the rail wheels is on the inside of the corresponding track.

CONTACT

• GRUPO RUZ, S.A. DE C.V.
• 126 MAIN ST, SAG HARBOR,
• NEW YORK, NY 11963-3007, USA
• www.gruporuz.com.mx
• SKU#563529 / MODEL# A27872
• Follow us on Social Media!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>