XtraLight B07WN24R73 LED Combo Exit-Emergency Light Instruction Manual

XtraLight B07WN24R73 LED Combo Exit-Emergency Light

INSTALLATION

INSTALLATION INSTRUCTIONS FOR LED COMBO EXIT/EMERGENCY LIGHT
When using electrical equipment, always adhere to basic safety precautions including the following:

IMPORTANT

• The battery in this unit may not be fully charged. After electricity is connected to the unit, let the battery charge for at least 24 hours, then normal operation of this unit should take effect. To check, press
• TEST button. The emergency LED lamps should illuminate.
• When re-lamping, use only the LED lamps specified in the fixture. Using other lamp types may result in transformer damage or unsafe conditions.

INSTALLATION (CEILING MOUNT)

1. Remove the faceplate and set it aside.
2. Connect 20-inch jumper leads to AC input leads in J-Box. Fasten the J-Box bracket to J-Box. Use black wire for 120V. Use orange or red wire for 277V. The white wire is common.
3. Fasten the canopy to the J-Box bracket.
4. Remove the canopy hole cover on the top and snap the housing to the canopy.
5. Connect and trim input leads slide through the canopy and connect to supply leads in the J-Box.
6. Connect the battery only after continuous power can be provided to the unit.
7. Remove proper chevron(s) as required.
8. Secure faceplate(s) to housing

INSTALLATION (WALL MOUNT)

1. Remove the faceplate and backplate and set aside.
2. Connect 20-inch jumper leads to AC input leads in J-Box. Fasten the J-Box bracket to J-Box. Use black wire for 120V. Use orange or red wire for 277V. The white wire is common.
3. Remove necessary knockouts and fasten the back plate to the J-Box cover.
4. Snap housing onto to back plate.
5. Connect and trim input leads slide through the hole in the backplate and connect to supply leads in J-Box.
6. Connect the battery only after continuous AC power can be provided to the unit.
7. Secure faceplate (s) to housing.

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

1. Do not use outdoors.

2. Equipment should be mounted securely in locations and at heights where it will not be readily subjected to tampering by unauthorized personnel

3. Do not mount near gas or electric heaters.

4. Cap unused wires with enclosed wire nuts or other approved method.

5. Do not use this equipment for anything other than its intended use.

6. The use of accessory equipment not recommended by the manufacturer will void the product listing and warranty and may cause an unsafe condition.

7. Disconnect AC power before servicing and installation.

8. Consult local building code for approved wiring and installation.

9. Use caution when servicing batteries.
   Battery acid can cause burns to the skin and eyes.
   If acid is spilled on the skin or eyes, flush the acid with fresh water and contact a physician immediately.

10. Any service on this equipment should be performed by qualified personnel only.

11. Make sure wire terminations are secure and leads are properly tucked in appropriate wire channels.

WIRING DIAGRAM

Connection of remote emergency light(If Applicable)

• Use Yellow & Blue wire for remote fixture(s). Route wires outside of the fixture separately or with AC supply wires.
• Make sure to keep all wires out of the way of the EXIT LEGEND so there are no shadows.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>